Owner's Manual

En 24
Speakers to be connected
If you have nine speakers, you can connect the both surround back speakers and front
presence speakers. In this case, the unit automatically changes the speakers to be used,
depending on the input signal and CINEMA DSP.
If you have seven speakers, use two of them as surround back speakers (*1) or front presence
speakers (*2).
If you have five speakers, use two of them as surround speakers (*3) or front presence speakers
(*4).
X
• You can also connect up to 2 subwoofers (with built-in amplifier) to the unit.
• When apply this speaker configuration, set “Power Amp Assign” (p.123) to “Basic” (default).
• To use an external power amplifier (Hi-Fi amplifier, etc.) to enhance speaker output, see “Connecting an
external power amplifier” (p.31).
Cables necessary for connection (commercially available)
Speaker cables (x the number of speakers)
Audio pin cable (two for connecting two subwoofers)
Connection diagram
Refer to the following diagram and connect the speakers to the unit.
Y
When using only one surround back speaker, connect it to the SINGLE jack (L side).
Speaker type
Speaker system
(the number of channels)
7.1/5.1.2 5.1 2.1
Front (L/R) 1 2 (((
Center 3 ((
Surround (L/R) 4 5 ()*3
Surround back (L/R) 6 7 )*1
Front presence (L/R) E R )*2 )*4
Subwoofer 9 (((
–
+
–
+
1
2
ZONE OUT
ZONE 2
SPEAKERS
CENTER FRONT
SURROUND BACK
SURROUND
F.PRESENCE
R L R R RL L L
ZONE 2
SINGLE
ZONE 2/BI-AMP
PRE OUT
SUBWOOFER CENTERFRONT SURROUND SUR. BACK
(SINGLE)
EXTRA SP1
EXTRA SP2
1
67
2
3
45
9
9
ER
The unit (rear)