Owner's Manual

En 127
4
Use the cursor keys to move the edit position and to select a value.
5
To confirm the setting, press ENTER.
6
To configure another network parameter, repeat steps 2 to 4.
7
To exit from the menu, press SETUP.
■ Network Standby
Selects whether the unit can be turned on from other network devices (network standby).
Settings
With an advanced energy saving design, this product achieves a low power consumption of not
more than two watts when in Network Standby mode.
■ MAC Address Filter
Sets the MAC address filter to limit access to the unit from other network devices.
Filter
Enables/disables the MAC address filter.
Settings
X
AirPlay (p.90) and DMC (p.128) operations are not subject to the MAC address filter.
MAC Address 1-10
Specifies the MAC addresses (up to 10) of the network devices that will be permitted access to
the unit when “Filter” is set to “On”.
■ Setup procedure
1
Use the cursor keys to select an MAC address number and press ENTER.
2
Use the cursor keys to move the edit position and to select a value.
3
To confirm the setting, press ENTER.
4
To exit from the menu, press SETUP.
Off Disables the network standby function.
On
Enables the network standby function.
(The unit consumes more power than when “Off” is selected.)
Auto
Enables the network standby function.
(If “Network Connection” is set to “Wired”, the unit is set to the power saving
mode when the network cable is disconnected.)
Off Disables the MAC address filter.
On
Enables the MAC address filter. In “MAC Address 1-10”, specify the MAC addresses
of the network devices that will be permitted access to the unit.