Owner's Manual

En 130
Multi Zone
Configures the multi zone settings.
■ Information
Displays information about Zone2.
Choices
■ Zone2
Configures the Zone2 settings.
Volume
Enables/disables volume adjustments for Zone2 output.
If you have connected an external amplifier with volume control to the unit, disable volume
adjustments for Zone2.
Settings
X
This setting is not available depending on the “Power Amp Assign” setting.
Max Volume
Sets the Zone2 limit value of the volumes.
Setting range
-60.0 dB to +15.0 dB (5.0 dB increments), +16.5
dB [20.5 to 95.5 (5.0 increments), 97.0]
X
This setting is available only when “Volume” is set to “Variable”.
Initial Volume
Sets the Zone2 initial volume for when the unit is turned on.
Settings
X
This setting is available only when “Volume” is set to “Variable”.
Audio Delay
Adjusts the Zone2 audio output timing so that the audio is synchronized with the video.
Setting range
0
ms to 100 ms (1 ms increments)
Monaural
Switches between stereo and monaural for Zone2 output.
Settings
On/Off Displays the status of Zone2.
Input The input source selected for Zone2.
Volume The volume setting for Zone2.
Tone Control
Adjusts the level of high-frequency range and low-frequency range for Zone2
output.
Fixed Disables volume adjustments for Zone2 output.
Variable
Enables volume adjustments for Zone2 output.
Off Sets the level at the volume level of the unit when it last entered standby mode.
On
Sets at Mute or the specified volume level (-80 dB to +16.5 dB, 0.5 dB increments) [0.5 to
97.0 (0.5 increments)].
(This setting works only when the initial volume is set lower than “Max Volume”.)
Off
Produces stereo sounds in Zone2.
On Produces monaural sounds in Zone2.