Owner's Manual

En 25
Connecting speaker cables
Speaker cables have two wires. One is for connecting the negative (-) terminal of the unit and
the speaker, and the other is for the positive (+) terminal. If the wires are colored to prevent
confusion, connect the black wire to the negative and the other wire to the positive terminal.
1
Remove approximately 10 mm (3/8”) of insulation from the ends of the speaker cable, and
twist the bare wires of the cable firmly together.
2
Loosen the speaker terminal.
3
Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the
terminal.
4
Tighten the terminal.
Using a banana plug
(U.S.A., Canada, China, Brazil and General models only)
1
Tighten the speaker terminal.
2
Insert a banana plug into the end of the terminal.
Connecting the subwoofer (with built-in amplifier)
Use an audio pin cable to connect the subwoofer.
FRONT
+
11
2
2
4
4
33
+ (red)
– (black)
FRONT
+
11
22
Banana plug
SUBWOOFER
PRE OUT
CENTER
SUR. BACKSURRUND
1
2
SURROUND BACK
L
Audio pin cable