User's Manual

En 140
Selecting the HDMI 4K signal format (4K MODE)
Selects the format of signals input/output at the unit when HDMI 4K compatible TV and
playback device are connected to the unit.
Settings
Format
Y
When “MODE 1” is selected, use a Premium High Speed HDMI Cable or Premium High Speed Cable with Ethernet.
Switching the DTS format notification setting (DTS MODE)
Switches the DTS format notification setting.
This setting informs the video device (such as BD/DVD player) about the DTS formats that the
unit supports.
Settings
Backing up/recovering the settings (BACKUP/RESTORE)
Backups and restores all the unit's setting to a USB memory device. Prepare a USB memory
device using FAT16 or FAT32 format in advance.
Choices
■ Backup/rstore procedure
1
Connect the USB memory device to the USB jack on the front panel.
2
To start the process, press STRAIGHT to select “BACKUP” or “RESTORE” and then press INFO
on the front panel.
3
Press INFO again after the confirmation message appears on the front display.
X
To cancel the operation, press STRAIGHT.
MODE 1
Inputs/outputs 4K signals shown in the table below.
Depending on the connected device or HDMI cables, video may not be displayed
correctly. In this case, select “MODE 2”.
MODE 2 Inputs/outputs 4K signals shown in the table below.
MODE 1 MODE 2
8 bit 10 bit 12 bit 8 bit 10 bit 12 bit
4K/60, 50 Hz
RGB 4:4:4 ,- -
YCbCr 4:4:4 ,- -
YCbCr 4:2:2 ,-
YCbCr 4:2:0 ,,-
4K/30, 25, 24 Hz
RGB 4:4:4 ,,-
YCbCr 4:4:4 ,,-
YCbCr 4:2:2 ,,
MODE 1
4K MODE
MODE 1
This mode conforms to the DTS:X standard.
Use this setting under normal circumstances.
MODE 2
Use this setting if the video device (such as BD/DVD player) fails to properly output
a DTS signal even when it is playing back DTS-HD or DTS:X content.
BACKUP Creates backup of the settings of the unit in the USB memory device.
RESTORE
Restores the settings of the unit from the backup (available only when backup has
been created).
MODE 1
DTS MODE
BACKUP
BACKUP/RESTORE