Operation Manual

CONFIGURATIONS ➤ Configuring various functions (Setup menu) En 139
3
To exit from the menu, press ON SCREEN.
• You cannot assign both COAXIAL and OPTICAL jacks to the same input source.
■ Display Set
Configures the settings related to the front display and TV screen display.
Adjusts the brightness of the front display.
Setting range
-4 to 0
(higher to brighten)
• The front display may become dark when “ECO Mode” (p.141) is set to “On”.
Selects whether to display short messages on the TV screen when the unit is
operated (such as input selection and volume adjustment).
Settings
Selects the image to be used as wallpaper on the TV.
Settings
■ Trigger Output1, Trigger Output2
Sets the TRIGGER OUT 1–2 jacks to function in sync with the power status of each zone
or input switching.
Specifies the condition for the TRIGGER OUT jack to function.
Settings
Source
Specifies the output level of the electronic signal transmitted with each input,
switching when “Trigger Mode” is set to “Source”.
Choices
AV 1–7, V-AUX, AUDIO 1–4, PHONO, TUNER, (network sources), USB, MULTI CH
Settings
Manual
Switches the output level for electronic signal transmission manually when “Trigger
Mode” is set to “Manual”. This setting can also be used to confirm proper function
of the external device connected via the TRIGGER OUT jack.
Choices
Dimmer (Front Display)
Short Message
On Displays short messages on the TV screen.
Off Does not display short messages on the TV screen.
Wallpaper
Picture 1, Picture 2,
Picture 3
Displays the selected image on the TV screen when there is no video
signal.
Gray
Displays a gray background on the TV screen when there is no video
signal.
Trigger Mode
Power
The TRIGGER OUT jack functions in sync with the power status of the
zone specified with “Target Zone”.
Source
The TRIGGER OUT jack functions in sync with the input switching in
the zone specified with “Target Zone”.
An electronic signal is transmitted according to the setting made in
“Source”.
Manual
Select this to manually switch the output level for electronic signal
transmission with “Manual”.
Low
Stops the electronic signal transmission when you switch to the input
source specified in this option.
High
Transmits the electronic signal when you switch to the input source
specified in this option.
Low Stops the electronic signal transmission.
High
Transmits the electronic signal.