Owner's Manual

4 Use the cursor keys and ENTER to select
"Setup"
~ "Speaker" --+ "Manual Setup" --+
"Power Amp Assign".
5 Use the cursor keys to select
"9ch
+ 1 ZONE" and press ENTER.
6 Press ENTER twice, use the cursor keys to
select "Zone2", and press ENTER again.
This sets the EXTRA SP 2 terminals to be used
for Zone2 output.
7 Press ON SCREEN to exit from the
on-screen menu.
Controlling Zone2
Follow the procedure below to enable Zone2 output and
select
an input source for Zone2.
1 Press ZONE repeatedly until "ZONE2"
lights up in the display window.
This enables you to control Zone2 with the
remote control.
RECEIVER c.:J
Display window
AV1-4
V-AUX
AUDIO
1-4
PHONO
USB
NET
TUNER
ZONE
2 Press RECEIVER C).
Each time you press the key, Zone2 is enabled
or disabled.
When Zone2
is enabled, "ZONE2" lights up in
the front display.
Lights up
3 Use the following keys to select an input
source.
AV 1-4: AV 1-4 (AUDIO) jacks
V-AUX: VIDEO AUX (AUDIO) jacks (on the front
panel)
AUDIO 1-4: AUDIO 1-4 (AUDIO) jacks
PHONO: PHONO jacks
USB: USB jack (on the front panel)
NET: NETWORK jack (press repeatedly to
select a desired network source)
TUNER: FM/AM radio
0
• If you have made more than one audio connection for AV 1-4,
V-AUX or AUDIO 1-2, audio signals input to the unit from the
external device is determined according to the "Audio Select"
setting
in the "Option" menu. For details, refer to the Owner's
Manual
in the supplied CD-ROM.
•
You cannot select USB and network sources exclusively tor
each zone. For
example, if you select "SERVER" for Zone2
when
"USB" is selected tor the main zone, the input source tor
the main zone
also switches to "SERVER".
4 Start playback on the external device or
select a radio station.
For details about the playback operation, refer to
the instruction manual for the external device or
Owner's Manual
on the supplied CD-ROM.
3