Owner's Manual

CONFIGURATIONS ➤ Configuring various functions (Setup menu) En 121
■ Initial Volume
Sets the initial volume when the receiver is turned on.
Settings
■ Pure Direct Mode
Selects whether to output video signals during the Pure Direct mode (p.69).
Settings
■ Adaptive DSP Level
Selects whether to automatically adjust the CINEMA DSP effect level.
Settings
■ VPS
(RX-A3030 only)
Selects whether to create Virtual Presence Speaker (VPS) using the front, center, and
surround speakers. When VPS is enabled, the unit creates front VPS when no front
presence speakers are connected, and creates rear VPS when front presence
speakers are connected but no rear presence speakers (p.65).
Settings
• Depending on the installation height of the surround speakers, VPS may not be effective. In this case, set
“VPS” to “Off”.
Off (default)
Sets the level to the volume level of the unit when it last entered
standby mode.
On
Sets at Mute or the specified volume level (-80.0 dB to +16.5 dB, 0.5
dB increments).
(Specify a volume level which is lower than the “Max Volume” setting.)
Auto (default)
Automatically outputs video signals when any videos are input from
the selected input source or an input source that can be operated with
the on-screen display is selected. When no video signals are input,
the wall paper is displayed.
Video Off Does not output video signals including the wall paper.
Off Does not adjust the effect level automatically.
On (default)
Adjusts the effect level automatically according to the YPAO
measurement results and the volume level.
Off Disables Virtual Presence Speaker (VPS).
On (default) Enables Virtual Presence Speaker (VPS).