Owner's Manual

CONFIGURATIONS ➤ Configuring various functions (Setup menu) En 136
Multi Zone
Configures the multi zone settings.
■ Main Zone Set
Configures the main zone setting.
Changes the zone name (for main zone) displayed on the front display or TV
screen.
■ Procedure
1
Press ENTER to enter the name edit screen.
2
Use the cursor keys and ENTER to rename and select “ENTER” to confirm the
entry.
• To clear the entry, select “CLEAR”.
3
Use the cursor keys to select “OK” and press ENTER.
• To restore the default setting, select “RESET”.
4
To exit from the menu, press ON SCREEN.
■ Zone2 Set, Zone3 Set
Configures the Zone2 or Zone3 settings.
Enables/disables volume adjustments for Zone2 or Zone3 output.
If you have connected an external amplifier with volume control to the unit, disable
the volume adjustment for the corresponding zone.
Settings
• This setting is not available depending on the “Power Amp Assign” setting (p.124).
Sets the Zone2 or Zone3 maximum volume to prevent excessive loudness.
Setting range
-30.0 dB to +15.0 dB (5.0 dB increments), +16.5
dB
• This setting is available only when “Volume” is set to “Variable”.
Sets the Zone2 or Zone3 initial volume for when the unit is turned on.
Settings
• This setting is available only when “Volume” is set to “Variable”.
Zone Rename
Volume
Fixed Disables volume adjustments for Zone2 or Zone3 output.
Variable
Enables volume adjustments for Zone2 or Zone3 output.
Max Volume
Initial Volume
Off
Sets the level at the volume level of the unit when it last entered standby
mode.
On
Sets at Mute or the specified volume level (-80.0 dB to +16.5 dB, 0.5 dB
increments).
(Specify a volume level which is lower than the “Max Volume” setting.)