User Manual

En 153
Configuring the system settings
(ADVANCED SETUP menu)
Configure the system settings of the unit while viewing the front display.
1
Set the unit to standby mode.
2
While holding down STRAIGHT on the front panel, press MAIN ZONE z.
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press MAIN ZONE z to set the unit to standby mode and turn it on again.
The new settings take effect.
ADVANCED SETUP menu items
X
Default settings are underlined.
MAIN ZONE z STRAIGHT
PROGRAM
Item Function Page
SPEAKER IMP. Changes the speaker impedance setting. 154
REMOTE SENSOR Turns on/off of the remote control sensor on the main unit. 154
REMOTE CON AMP Selects the unit’s remote control ID. 154
TUNER FRQ STEP
(Brazil, Asia and General models only)
Changes the FM/AM tuning frequency setting.
154
TV FORMAT Switches the video signal type. 155
MONITOR CHECK Removes the limitation on HDMI video output. 155
4K MODE Selects the HDMI 4K (60 Hz/50 Hz) signal format. 155
DTS MODE
This setting informs the player about the DTS formats that the unit
supports.
155
RECOV./BACKUP
Creates backup of the settings of the unit, or recovers the settings from
the backup.
156
INITIALIZE Restores the default settings. 156
FIRM UPDATE Updates the firmware. 156
VERSION Checks the version of firmware currently installed on the unit. 156