Owner’s Manual

Configuring the system settings (ADVANCED SETUP menu)
Configure the system settings of the unit while viewing the front display.
1
Set the unit to standby mode.
2
While holding down STRAIGHT on the front panel, press
z (power).
(power)
z
STRAIGHTPROGRAM
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press z (power) to set the unit to standby mode and turn it on
again.
The new settings take effect.
ADVANCED SETUP menu items
Note
Default settings are underlined.
Item Function Page
SP IMP.
(U.S.A. and Canada models only)
Changes the speaker impedance setting.
p.112
REMOTE ID Selects the unit’s remote control ID. p.113
TV FORMAT Switches the video signal type of HDMI output. p.113
4K MODE Selects the HDMI 4K signal format. p.113
DTS MODE
This setting informs the player about the DTS formats that the unit
supports.
p.114
INIT Restores the default settings. p.114
UPDATE Updates the firmware. p.114
VERSION Checks the version of firmware currently installed on the unit. p.114
Changing the speaker impedance setting (SP IMP.)
(U.S.A. and Canada models only)
ENHANCER
LINK
ECO
MASTER
OUT 2
-
R es Hi YPAO VOL. A
-
DRC
SLEEP
STEREO
PARTY
TUNED
ZONE
3 B2 A
VOL .
FPR
SL SW SR
SBL SB SBR
FPL
MUT E VI RTU AL
SP IMP.••8¬MIN
Change the unit’s speaker impedance settings depending on the impedance of the
speakers connected.
Settings
6 Ω MIN Select this option when you connect 6-ohm speakers to the unit.
8 Ω MIN Select this option when you connect 8-ohm or higher speakers to the unit.
En
112