Owner's Manual

Table Of Contents

Speaker systems and speakers to be connected

Select the speaker layout for the number of speakers that you are using and place the

speakers and subwoofer in your room.

Speaker type

Speaker system

(the number of channels)

7.1/5.1.2 5.1 2.1

Front (L/R) 1/2

  

Center 3

 

Surround (L/R) 4/5



*3

Surround back (L/R) 6/7

*1

Presence (L/R) E/R

*2 *4

Subwoofer 9

  

If you have nine speakers, you can use the both surround back speakers and

presence speakers. In this case, the unit automatically changes the speakers to be

used, depending on the input signal and CINEMA DSP.

If you have seven speakers, use two of them as surround back speakers (*1) or

presence speakers (*2).

If you have five speakers, use two of them as surround speakers (*3) or presence

speakers (*4).

Note

▪ “5.1.2-channel” denotes “standard 5.1-channel plus 2 for overhead speaker channels”.

▪ When using surround back speakers, be sure to connect the surround back left and right speakers. Using

only one surround back speaker was discontinued.

▪ You can also connect up to 2 subwoofers (with built-in amplifier) to the unit.

Speaker requirements

Speakers and subwoofers to be connected to the unit must meet the following

requirements:

• Under its default settings, the unit is configured for 8-ohm speakers. When

connecting 6-ohm speakers, set the unit’s speaker impedance to “6 Ω MIN”. For

details, see the following:

– “Setting the speaker impedance” (p.19)

• Use a subwoofer with built-in amplifier.

Note

▪ Prepare the number of speakers according to your speaker system.

▪ Be sure to connect the front left and right speakers.