Owner’s Manual

Configuring the advanced settings (ADVANCED SETUP menu)
Basic operation of the ADVANCED SETUP menu
Perform the following basic procedure to operate the “ADVANCED SETUP” menu while
viewing the front display.
1
Set the unit to standby mode.
2
While holding down STRAIGHT on the front panel, press
z (power).
(MAIN ZONE)
z
STRAIGHT
PROGRAM
The top item and its setting of the “ADVANCED SETUP” menu appear on
the front display.
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press z (power) to set the unit to standby mode and turn it on
again.
This completes the settings.
NOTE
For details on the default settings, see the following:
▪ “Default settings of the ADVANCED SETUP menu” (p.202)
ADVANCED SETUP menu items
Use the following table to configure system settings of the unit.
Item Function Page
SP IMP. Changes the speaker impedance setting. p.152
REMOTE ID Selects the unit’s remote control ID. p.152
TU
(Asia and General models only)
Changes the FM/AM tuning frequency setting.
p.152
TV FORMAT Switches the video signal type of HDMI output. p.152
MON.CHK Removes the limitation on HDMI video output. p.153
4K MODE Selects the HDMI 4K signal format. p.153
DTS MODE
Selects the information to be sent to the BD player connected to
the unit about the DTS formats that the unit supports.
p.154
BKUP/RSTR Backups and restores all the settings for the unit. p.154
INIT Restores the default settings. p.155
UPDATE Updates the firmware. p.155
VERSION Checks the version of firmware currently installed on the unit. p.155
En
151