Operation Manual

REMOTE CONTROL FEATURES

ADVANCED

OPERATION

English

You can control other components by setting the

appropriate remote control codes. Codes can be set up for

each input area. For a complete list of available remote

control codes, refer to “LIST OF REMOTE CONTROL

CODES” at the end of this manual.

The following table shows the default component

(Library: component category) and the remote control

code for each area.

Remote Control Code Default Settings

You have control only over this unit and other YAMAHA

tuners.

You must set TV remote control codes at the DTV/CBL button

(other remote control codes can be set at any input selector

button except DTV/CBL).

You may not be able to operate your YAMAHA component even

if a YAMAHA remote control code is initially set as listed above.

In this case, try to set other YAMAHA remote control code(s).

1 While holding down CODE SET, press an

input selector button

to select the

component you want to set up.

You must press and hold CODE SET throughout this

procedure.

2 With CODE SET depressed, use the numeric

buttons to enter the three-digit remote

control code for the component to be used.

Refer to “LIST OF REMOTE CONTROL CODES”

at the end of this manual.

To reset the code, enter the default code for each

component shown in the previous table.

• If the manufacturer of your component has more than one code,

try each of them until you find the correct one.

• You can only assign one remote control code to each input

selector button.

Setting remote control codes

Input area

Component