User Manual

En 153
■ Trigger Output1, Trigger Output2
Sets the TRIGGER OUT 1-2 jacks to function in sync with the power status of each zone or input
switching.
Trigger Mode
Specifies the condition for the TRIGGER OUT jack to function.
Settings
Source
Specifies the output level of the electronic signal transmitted with each input, switching when
“Trigger Mode” is set to “Source”.
Choices
AV 1-7, AUX, AUDIO 1-4*, PHONO, TUNER, (network sources), Bluetooth, USB
* AUDIO 4: RX-V3085 only
Settings
Manual
Switches the output level for electronic signal transmission manually when “Trigger Mode” is
set to “Manual”. This setting can also be used to confirm proper function of the external device
connected via the TRIGGER OUT jack.
Choices
Target Zone
Specifies the zone with which the TRIGGER OUT jack functions are synchronized.
Settings
Power
The TRIGGER OUT jack functions in sync with the power status of the zone
specified with “Target Zone”.
Source
The TRIGGER OUT jack functions in sync with the input switching in the zone
specified with “Target Zone”.
An electronic signal is transmitted according to the setting made in “Source.”
Manual
Select this to manually switch the output level for electronic signal transmission
with “Manual”.
Low
Stops the electronic signal transmission when you switch to the input source
specified in this option.
High
Transmits the electronic signal when you switch to the input source specified in
this option.
Low Stops the electronic signal transmission.
High
Transmits the electronic signal.
Main
When “Trigger Mode” is set to “Power”, electronic signal transmission is
synchronized with the power status of the main zone.
When “Trigger Mode” is set to “Source”, electronic signal transmission is
synchronized with the input switching in the main zone.
Zone2
When “Trigger Mode” is set to “Power”, electronic signal transmission is
synchronized with the power status of Zone2.
When “Trigger Mode” is set to “Source”, electronic signal transmission is
synchronized with the input switching in Zone2.
Zone3
When “Trigger Mode” is set to “Power”, electronic signal transmission is
synchronized with power status of Zone3.
When “Trigger Mode” is set to “Source”, electronic signal transmission is
synchronized with input switching in Zone3.
Zone4
When “Trigger Mode” is set to “Power”, electronic signal transmission is
synchronized with power status of Zone4.
When “Trigger Mode” is set to “Source”, electronic signal transmission is
synchronized with input switching in Zone4.
All
When “Trigger Mode” is set to “Power”, electronic signal transmission is
synchronized with the power status of any zone.
When “Trigger Mode” is set to “Source”, electronic signal transmission is
synchronized with the input switching in any zone.