Owner's Manual

En 156
ADVANCED SETUP menu items
X
Default settings are underlined.
Changing the speaker impedance setting (SPEAKER IMP.)
Change the unit’s speaker impedance settings depending on the impedance of the speakers
connected.
Settings
Turning on/off the remote control sensor
(REMOTE SENSOR)
Turn on/off the remote control sensor on the main unit. While the remote control sensor is
turned off, you cannot control the unit from the remote control.
Settings
Selecting the remote control ID (REMOTE ID)
Change the unit’s remote control ID so that it matches the remote control’s ID (default: ID1).
When using multiple Yamaha AV receivers, you can set each remote control with a unique
remote control ID for its corresponding receiver.
Settings
ID1
, ID2
■ Changing the remote control ID of the remote control
1
To select ID1, hold down the cursor key (e) and SCENE1 together for 5 seconds.
To select ID2, hold down the cursor key (e) and SCENE2 together for 5 seconds.
X
If the remote control ID does not match that of the unit, “RemID Mismatch” appears on the unit’s front
display when the remote control is operated.
Item Function Page
SPEAKER IMP. Changes the speaker impedance setting. 156
REMOTE SENSOR Turns on/off of the remote control sensor on the main unit. 156
REMOTE ID Selects the unit’s remote control ID. 156
TV FORMAT Switches the video signal type. 157
MONITOR CHECK Removes the limitation on HDMI video output. 157
4K MODE Selects the HDMI 4K (60 Hz/50 Hz) signal format. 157
DTS MODE Switches the DTS format notification setting. 158
BACKUP/RESTORE
Creates backup of the settings of the unit, or recovers the settings from
the backup.
158
INITIALIZE Restores the default settings. 158
FIRM. UPDATE Updates the firmware. 159
VERSION Checks the version of firmware currently installed on the unit. 159
6 Ω MIN
Select this option when you connect 6-ohm speakers to the unit. You can also use
4-ohm speakers as the front speakers.
8 Ω MIN
Select this option when you connect 8-ohm or higher speakers to the unit.
8¬MIN
SPEAKER¡IMP.
ON Turns on the remote control sensor.
OFF Turns off the remote control sensor.
ON
REMOTE SENSOR
ID1
REMOTE ID