Owner's Manual

En 29
Connection diagram
Refer to the following diagram and connect the speakers to the unit.
Connecting speaker cables
Speaker cables have two wires. One is for connecting the negative (-) terminal of the unit and
the speaker, and the other is for the positive (+) terminal. If the wires are colored to prevent
confusion, connect the black wire to the negative and the other wire to the positive terminal.
1
Remove approximately 10 mm (3/8”) of insulation from the ends of the speaker cable, and
twist the bare wires of the cable firmly together.
2
Loosen the speaker terminal.
3
Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the
terminal.
4
Tighten the terminal.
Using a banana plug
(China model only)
1
Tighten the speaker terminal.
2
Insert a banana plug into the end of the terminal.
Connecting the subwoofer (with built-in amplifier)
Use an audio pin cable to connect the subwoofer.
1
2
ZONE OUT/PRE OUT
ZONE 2/
F.PRESENCE
ZONE 3/
R.PRESENCE
SPEAKERS
CENTER FRONTSURROUND BACKSURROUND
R.PRESENCE
R L R R RL L
R L
L R L
ZONE 2/ZONE 3/F.PRESENCE ZONE 2/ZONE 3/BI-AMP
PRE OUT
(REAR)
SUBWOOFER
CENTER FRONTFRONT SURROUND SUR. BACK
(FRONT)
EXTRA SP2
F.PRESENCE
EXTRA SP1
12
3
45
99
T
6 7
Y
ER
The unit
(rear)
FRONT
+
11
2
2
4
4
33
+ (red)
– (black)
FRONT
+
11
22
Banana plug
(
FRONT
)
(REAR)
SUBWOOFER
PRE OUT
CENTER
SUR. BACKSURRUND
1
2
SURROUND BACK
L
Audio pin cable