User's Manual

Switching the video signal type (TV FORMAT)
ENHANCER
LINK
ECO
MASTER
OUT 2
-
R es Hi YPAO VOL. A
-
DRC
SLEEP
STEREO
PARTY
TUNED
ZONE
3 B2 A
VOL .
FPR
SL
SW SR
SBL SB SBR
FPL
MUT E VIR TUA L
TV FORMAT•NTSC
Switch the video signal type of HDMI output so that it matches to the format of your TV.
Since the unit automatically selects the video signal type so that it matches to the TV, it
is unnecessary to change the setting normally. Change the setting only when images
on the TV screen do not appear correctly.
ADVANCED SETUP menu
“TV FORMAT”
Settings
NTSC, PAL
Selecting the HDMI 4K signal format (4K MODE)
ENHANCER
LINK
ECO
MASTER
OUT 2
-
R es Hi YPAO VOL. A
-
DRC
SLEEP
STEREO
PARTY
TUNED
ZONE
3 B2 A
VOL .
FPR
SL
SW SR
SBL SB SBR
FPL
MUT E VIR TUA L
4K MODE•MODE 1
Selects the format of signals input/output at the unit when HDMI 4K compatible TV and
playback device are connected to the unit.
ADVANCED SETUP menu
“4K MODE”
Settings
MODE 1
Inputs/outputs 4K signals shown in the following table. Depending on the
connected device or HDMI cables, video may not be displayed correctly.
In this case, select “MODE 2”.
MODE 2 Inputs/outputs 4K signals shown in the following table.
Note
When “MODE 1” is selected, use a Premium High Speed HDMI Cable or Premium High Speed Cable with
Ethernet.
Format
MODE 1 MODE 2
8 bit 10 bit 12 bit 8 bit 10 bit 12 bit
4K/60, 50 Hz
RGB 4:4:4
4
– –
YCbCr 4:4:4
4
– –
YCbCr 4:2:2
4
–
YCbCr 4:2:0
4 4
–
4K/30, 25, 24 Hz
RGB 4:4:4
4 4
–
YCbCr 4:4:4
4 4
–
YCbCr 4:2:2
4 4
En
87