Owner's Manual

FCC
INFORMATION
(for
US
customers)
IMPORTANT NOTICE:
DO
NOT
MODIFY
THIS UNIT!
This
product,
when
installed
as
indicated
in
the
instructions
contained
in
this
manual,
meets
FCC
requirements.
Modifications
not
expressly
approved
by
Yamaha
may
void
your
authority,
granted
by
the
FCC,
to
use
the
product.
2
IMPORTANT:
When
connecting this product to accessories and/or another product use only high
quality shielded cables. Cable/s supplied with this product
MUST
be used. Follow all installation
instructions. Failure to follow instructions could void
your
FCC authorization to use this product
in
the
USA.
3
NOTE:
This product has been tested and found to comply with the requirements listed in FCC
Regulations,
Part
15
for Class
"B"
digital devices.
Compliance
with these requirements provides a
reasonable level
of
assurance that your use
of
this product in a residential environment will not result
in harmful interference with
other
electronic devices.
This equipment generates/uses radio frequencies and,
if
not installed and used according to the
instructions found
in
the users manual, may cause interference harmful to the operation
of
other
electronic devices.
Compliance with FCC regulations does not guarantee that interference will not
occur
in all installations.
If this product is found to be the source
of
interference, which can be determined by turning the unit
"OFF"
and
"ON",
please try to eliminate the problem by using
one
of
the following measures:
Relocate either this product
or
the device that is being affected by the interference.
Utilize power outlets that are on different branch (circuit breaker
or
fuse) circuits
or
install AC line filter/s.
In
the case
of
radio or TV interference, relocate/reorient the antenna.
If
the antenna lead-in is
300
ohm
ribbon lead, change the lead-in to coaxial type cable.
If these corrective measures
do
not produce satisfactory results, please contact the local retailer
authorized to distribute this type
of
product. If you can not locate the appropriate retailer, please contact
Yamaha
Corporation
of
America A/V Division,
6600 Orangethorpe
Avenue, Buena
Park,
CA
90620
,
USA.
The above statements apply
ONLY
to those products distributed by
Yamaha
Corporation
of
America
or
its subsidiaries.
FOR
CANADIAN
CUSTOMERS
To
prevent
electric
shock,
match
wide
blade
of
plug
to
wide
slot
and
fully
insert.
CAN
ICES-3(8)/NM8-3(8).
IMPORTANT
Please
record
the
serial
number
of
this
unit
in
the
space
below.
MODEL:
Serial
No.:
The
serial
number
is
located
on
the
rear
of
the
unit.
Retain
this
Owner's
Manual
in a
safe
place
for
future
reference.
COMPLIANCE
INFORMATION
STATEMENT
(DECLARATION
OF
CONFORMITY
PROCEDURE)
Responsible
Party: Yamaha
Corporation
of
America A/V Division
Address:
6600
Orangethorpe
Avenue,
Buena
Park,
CA
90620
Telephone: [phone] II
Type of Equipment:
AV
Receiver
Model Name:
RX-A860, RX-A760, RX-A660, RX-V781, RX-V681, RX-V581, RX-V481,
RX-V381 , HTR-3069,
TSR-5810
This device complies with
Part
15
of
FCC Rules and Industry Canada licence-exempt
RSS
standard(s).
Operation
is subject to the following two conditions:
(I)
this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation
of
this device.
FCC
CAUTION
Changes
or
modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part
15
of
the
FCC
Rules.
These
limits are designed to provide reasonable protection against harmful
interference
in
a residential installation. This equipment generates, uses and can radiate radio frequency
energy and,
if
not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur
in a particular
installation.
If
this equipment does cause harmful interference to radio
or
television reception, which can
be determined by turning the equipment
off
and on, the user is encouraged to try to correct the
interference by
one
or
more
of
the following measures:
- Reorient
or
relocate the receiving antenna.
- Increase the separation between the
equipment
and receiver.
-Connect
the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult
the dealer
or
an experienced radio/TV technician for help.
This
equipment
complies with FCC/IC radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines and
RSS-1 02
of
the IC radio
frequency (RF) Exposure rules. This
equipment
should be installed and operated keeping the radiator at
least
20cm
or
more away from person's body.
This transmitter must not be co-located
or
operated in conjunction with any
other
antenna
or
transmitter.
Do not use this unit within 22 em (9 inches)
of
persons with a heart pacemaker implant or defibrillator
implant.