Owner's Manual

23
CONNECTIONS
PREPARATION
English
If you are using 4 or 6 ohm speakers, set the impedance to
4 or 6 ohms as follows before turning on the power.
Be sure this unit is in the standby mode.
1 Turn off the power to this unit, and while
holding down STRAIGHT (EFFECT), press
STANDBY/ON.
This unit turns on, and the ADVANCED SETUP
menu appears in the front panel display.
2 Rotate PROGRAM to move through the menu
and select “SP IMP.”.
3 Press STRAIGHT (EFFECT) repeatedly to
select “4 Ω MIN”.
4 Press STANDBY/ON to turn off the power.
The setting you made is reflected the next time this
unit’s power is turned on.
When all connections are complete, turn on the power of
this unit.
1 Press STANDBY/ON (or SYSTEM POWER on
the remote control) to turn on the power of
this unit.
2 Turn on the video monitor connected to this
unit.
Speaker impedance setting
CAUTION
EFFECT
STRAIGHT
STANDBY
/ON
While holding
down, press
PROGRAM
EFFECT
STRAIGHT
STANDBY
/ON
Turning on the power
S VIDEO VIDEO OPTICALL AUDIO R
EFFECT
OPTIMIZER MIC
PROGRAM
PURE DIRECTINPUT MODETONE CONTROLSTRAIGHT
SPEAKERSPHONES
SILENT CINEMA
STANDBY
/ON
BA
MULTI CH
INPUT
VOLUME
VIDEO AUX
INPUT
LEVELNEXT
MEMORYFM/AM
PRESET/TUNING A/B/C/D/E
l PRESET/TUNING h
TUNING MODE
MAN'L/AUTO FM AUTO/MAN'L MONO
EDIT
1
TRANSMITCODE SET
STANDBY
SYSTEM
POWER
CD MD/CD-R TUNER
V-AU XDVD
AMP
POWERPOWER
VOLUME
TV MUTE TV INPUT
TV VOL TV CH
AVTV
VCR 1 DVR/VCR2
DTV/CBL
MULTI CH IN
SLEEP
1
STANDBY
/ON
SYSTEM
POWER
or
Front panel
Remote control