Owner's Manual
Table Of Contents
- English
- Français
- INTRODUCTION
- PRÉPARATIONS
- OPÉRATIONS DE BASE
- CORRECTIONS DE CHAMP SONORE
- OPÉRATIONS DÉTAILLÉES
- INFORMATIONS COMPLÉMENTAIRIES
- Deutsch
- EINLEITUNG
- VORBEREITUNG
- GRUNDLEGENDE BEDIENUNGSVORGÄNGE
- SOUNDFELDPROGRAMME
- WEITERFÜHRENDE BEDIENUNGSVORGÄNGE
- ZUSÄTZLICHE INFORMATIONEN
- Svenska
- Nederlands
- Русский
- ВВЕДЕНИЕ
- ПОДГОТОВКА
- ОСНОВНОЕ УПРАВЛЕНИЕ
- ПРОГРАММЫ ЗВУКОВОГО ПОЛЯ
- ДОПОЛНИТЕЛЬНЫЕ ОПЕРАЦИИ
- ДОПОЛНИТЕЛЬНАЯ ИНФОРМАЦИЯ
- LIST OF REMOTE CONTROL CODES
![](/manual/yamaha/rx-v657/owner-s-manual-english-french-german-swedish-dutch-russian/images/img-31.png)
29
AUTO SETUP
PREPARATION
English
Warnings after auto setup
Press j / i to display detailed information about individual warnings.
• If the ERROR or WARNING screens appears, check the cause of the problem, then perform the auto setup procedure again.
• If warning W-1 appears, corrections are made, but they may not be optimal.
• If warning W-2 or W-3 appears, no corrections are made.
• If error E-10 occurs repeatedly, please contact a qualified YAMAHA service center.
Warning message Cause Remedy
W-1:OUT OF PHASE
Speaker polarity is not correct. This message
may appear depending on the speakers even
when the speakers are connected correctly.
• Check the speaker connections for proper polarity
(+ / –).
W-2:OVER 24m
The distance between the speaker and the
listening position is 24 m or more.
• Move the speaker closer to the listening position.
• Check the speaker connections for proper polarity
(+ / –).
W-3:LEVEL ERROR
The difference of volume level among speakers
is excessive. (No level correction is made.)
• Readjust the speaker installation so that all speakers
are set in locations with similar conditions.
• Check the speaker connections for proper polarity
(+ / –).
• Use speakers of similar quality and efficiency.