Owner's Manual

@DDDB@DD

Setting the speaker impedance

This unit isconfigured for 8-ohm speakers at the factory.When connecting 6-ohm

speakers, set the speaker impedance to "6 £_MIN". In this case, you can also use 4-

ohm speakers as the front speakers.

Before connecting speakers, connect the power cable to an AC wall

outlet.

While holding down STRAIGHT on the front panel, press MAIN

ZONE _.

MAIN ZONE (D

STRAIGHT

Check that "SP IMP." is displayed on the front display.

Press STRAIGHT to select "6 £_ MIN".

5 Press MAIN ZONE (_) to set this unit to standby mode and remove

the power cable from the AC wall outlet.

Now you are ready to connect the speakers.

En 16