Owner's Manual

___Automatic speaker setup
The following screen appears on the TV.
• If any error message (such as E-l) or warning message (such as W-l)
appears, see "Error messages" (p.36) or "Warning messages" (p.37).
• To cancel the operation, disconnect the YPAO microphone before starting
the measurement.
• To check the measurement results, select "Result". For details, see
"Checking the measurement results" (p.35).
Use the cursor keys to select "Save/Cancer' and
press ENTER.
To save the measurement results, use the cursor
keys to select "SAVE" and press ENTER.
keys
ENTER
RETURN
5
• YPAO measurement is not performed correctly when any obstacles are in
the room.
• During the measuring process (about 3 minutes), keep stuff in the corners
or remove it from the room.
To start the measurement, use the cursor keys to
select "Measure" and press ENTER.
The measurement will start in 10 seconds. Press ENTER
again to start the measurement immediately.
The corrected speaker settings are applied.
• To cancel the measurement, press RETURN.
The following screen appears on the TV when the
measurement finishes.
• To finish the measurement without saving the result, select "CANCEU'.
Disconnect the YPAO microphone from this unit.
Now optimization of the speaker settings is complete.
Ca_tior'_
• Since the YPAO microphone is sensitive to heat, do not place the microphone
in any place where it will be subjected to direct sunlight or high temperatures
(top of an AV equipment, etc).
En 34