Owner's Manual

@@@D D D @D U Auto.,aticspeakersetup
Checking the measurement results
You can check the YPAO measurement results.
After the measurement, use the cursor keys to
select "Result" and press ENTER.
• You can also select "Result" from "Auto Setup" (p.88) in the "Setup" menu. In
this case, the previous measurement results are displayed.
The following screen appears.
ON SCREEN
keys
ENTER
RETURN
S To finish checking the results and return to the
previous screen, press RETURN.
Reloading the previous YPAO adjustments
When the speaker settings you have configured manually are not
suitable, follow the procedure below to discard the manual settings
and reload the previous YPAO adjustments.
2
In the "Setup" menu, select "Speaker", "Auto
Setup" and then "Result" (p.87).
Use the cursor keys to select "Setup Reload" and
press ENTER.
2
@ Measurement result items
@ Measurement result details
Use the cursor keys to select an item
Wiring
Polarity of each speaker
Normal: The speaker cable is connected with the
correct polarity (+/-).
Reverse: The speaker cable may be connected with
the reversed polarity (+/-).
Size
Size of each speaker (cross-over frequency of the
subwoofer)
Large: The speaker can reproduce low-frequency
signals effectively.
Small: The speaker cannot reproduce low-frequency
signals effectively.
Distance Distance from the listening position to each speaker
Level Output level adjustment for each speaker
S To exit from the menu, press ON SCREEN.
• A speaker with any problem is indicated with a red-boxed message.
En 35