Owner's Manual
Table Of Contents
- Easy Setup Guide
- Owners Manual (Supplied on CD-ROM)
- Video Signal Flow
- HDMI Information
- Optimizing the Speaker Settings Automatically (YPAO)
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Features
- Setup
- Playback
- Basic Playback Procedure
- Changing Input Settings with a Single Key (SCENE Function)
- Selecting the Sound Mode
- Listening to FM / AM
- Listening to SIRIUS Satellite Radio
- Playing Back Songs with iPod
- Playing Back Songs with Bluetooth Devices
- Playing Back Songs with USB Devices
- Playing Back Music Stored on a PC
- Internet Radio
- Playing Back Music in Multiple Rooms
- Useful Functions
- Configuring Settings Specific to an Individual Input Source (Option Menu)
- Configurations
- Programming the Remote Control
- Updating the Firmware
- FAQs
- Troubleshooting
- Messages
- Ideal Speaker Layout
- Glossary
- Video Signal Flow
- HDMI Information
- Specs
- Supplement Manuals Supplied on CD-ROM
- Scan of CD-ROM
- Warranty
En 96
■ Standby Through
Select whether to output videos/audio (input through HDMI jacks) to the TV when this
unit is in standby mode.
Settings
• This setting is available only when “HDMI Control” is set to “Off”.
Network
Configures the network settings.
■ IP Address
Configures the network parameters (IP address, etc).
❑ DHCP
Select whether to use a DHCP server.
Settings
❑ Manual Setup
Configures the network parameters of this unit manually when “DHCP” is set to “Off”.
Submenu
■ Network Standby
Selects whether to turn on this unit by the command from other network devices
(network standby).
Settings
■ MAC Address Filter
Sets the MAC address filter to limit access to this unit from other network devices.
❑ Mode
Enables/disables the MAC address filter.
Settings
❑ Address Setup
Specifies the MAC addresses (up to 10) of the network devices that will be permitted
access to this unit when “Mode” is set to “On”.
Off (default) Does not output videos/audio to the TV.
On
Outputs videos/audio to the TV.
(This unit consumes approximately 3 W of power.)
Off
Does not use a DHCP server. Configure the network parameters
manually.
On (default)
Uses a DHCP server to automatically obtain the network parameters (IP
address, etc.) of this unit.
IP Address Specifies an IP address.
Subnet Mask Specifies a subnet mask.
Default Gateway Specifies the IP address of the default gateway.
DNS Server (P) Specifies the IP address of the primary DNS server.
DNS Server (S) Specifies the IP address of the secondary DNS server.
Off (default) Disables the network standby function.
On
Enables the network standby function.
(This unit consumes approximately 5 W of power.)
Off (default) Disables the MAC address filter.
On
Enables the MAC address filter. In “Address Setup”, specify the MAC
addresses of the network devices that will be permitted access to this
unit.