Owner's Manual
Table Of Contents
- Easy Setup Guide
- Owners Manual (Supplied on CD-ROM)
- Video Signal Flow / Conversion
- HDMI Information
- Features
- Optimizing the Speaker Settings Automatically (YPAO)
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Preparations
- Speaker Layout
- Setting Speaker Impedance
- Connecting Speakers
- Jacks & Cable Types
- Connecting a TV
- Connecting Playback Devices
- Front Panel Connections
- Connecting the FM / AM Antennas
- Connecting to a Network
- Connecting an External Power Amplifier
- Connecting Recording Devices
- Connecting a Device Compatible with the Trigger Function
- Multi-Zone Connections
- Power Cable
- Selecting an On-Screen Menu Language
- Optimizing the Speaker Settings Automatically (YPAO)
- Playback
- Basic Playback Procedure
- Selecting the Input Source and Favorite Settings with One Touch (SCENE)
- Selecting the Sound Mode
- Listening to FM / AM Radio
- iPod
- USB Devices
- Playing Back Music Stored on Media Servers (PC / NAS)
- Listening to Internet Radio
- Playing Back iTunes / iPod Music via a Network (AirPlay)
- Playing Back Music in Multiple Rooms
- Viewing the Current Status
- Configuring Playback Settings for Different Playback Sources (Option Menu)
- Programming the Remote Control
- Configurations
- Updating the Unit’s Firmware
- Updating the Unit’s Firmware via the Network
- Video Signal Flow / Conversion
- HDMI Information
- Troubleshooting
- Error Messages
- FAQs
- Glossary
- Specs
- Index
- List of Remote Control Codes (Supplied on CD-ROM)
- Using the Pandora Service (Supplied on CD-ROM)
- Multi-Zone and Remote Control Functions
- Supplement for Web Control
- Using the Rhapsody Service
- Supplement for SiriusXM Internet Radio (Firmware Required for this Feature)
- Software Information
- Scan of CD-ROM
- Warranty
PREPARATIONS ➤ Connecting speakers En 21
Push-type speaker terminals
(RX-V675 only)
a Remove approximately 10 mm (3/8”) of insulation from
the ends of the speaker cable, and twist the bare wires of
the cable firmly together.
b Press down the tab.
c Insert the bare wires of the cable into the hole in the
terminal.
d Release the tab.
■ Connecting the subwoofer
Use an audio pin cable to connect the subwoofer.
Connecting front speakers that
support bi-amp connections
When using front speakers that support bi-amp
connections, connect them to the FRONT jacks and
SURROUND BACK/BI-AMP jacks.
To enable the bi-amp function, set “Power Amp Assign”
(p.91) in the “Setup” menu to “5ch BI-AMP” after
connecting the power cable to an AC wall outlet.
• The FRONT jacks and SURROUND BACK/BI-AMP/ZONE B jacks
output the same signals.
Z
ONE 2/F.PRESENCE
EX
TRA SP
aa
b
c
d
+ (red)
- (black)
Audio pin cable
12
3
45
9
FRONT CENTER SURROUND
SINGLE
SURROUND BACK/BI-AMP
SPEAKERS
SUBWOOFER
CENTER
ZONE2/F.PRESENCE
EXTRA SP
CENTER
1
2
The unit (rear)
Caution
• Before making bi-amp connections, remove any brackets or
cables that connect a woofer with a tweeter. Refer to the
instruction manual of the speakers for details. If you are not
making bi-amp connections, make sure that the brackets or
cables are connected before connecting the speaker cables.
• Surround back speakers cannot be used during bi-amp
connections.
1 2
Speaker connections
3 4 5 6 7 8 9 10