Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Features
- HDMI Information
- Supplied Accessories
- Parts & Controls
- Connections
- Getting Started
- Basic Operation
- Advanced Setup / Menu Operation
- Remote Control Operation
- Troubleshooting
- Glossary
- Specs
- Remote Control Codes
- Index
- Correction to Manual
- Front Panel Diagram
- Remote Control Diagram
- XM Channel Guide
- Warranty
Usmg
multi-zone
configuratIOn
•
Using
the
internal amplifier
of
this unit
Important safety notice
The EXTRA SP speaker terminals
of
this Receiver should not be connected to a Passive Loudspeaker Selector Box
or
more than one loudspeaker per channel.
Connection to a Passive Loudspeaker Selector Box
or
multiple speakers per channel could create an abnormally low
impedance load resulting in amplifier damage. See this owner's manual for correct usage.
Compliance with minimum speaker impedance information for all channels must be maintained at all times. This
information is found on the back panel
of
your Receiver.
Connect the speakers in the second zone to the EXTRA SP speaker terminals and then set the "EXTRA SP ASSIGN" to
"ZONE2" (see page 85).
Second zone
(Zone 2)
This unit
Main zone
~\4<~
•
You
can use the speakers connected EXTRA
SP
speaker terminals
as
the front speaker system
of
another zone. Set "EXTRA
SP
ASSIGN" to "ZONE B" (see page 85).
• When you use the internal amplifiers for the Zone 2 speakers, you can adjust the volume level and set the initial volume level and
maximum volume level
of
the Zone 2 speakers (see page 99).
You
can select and control Zone 2 by using the control
buttons on the front panel
or
on the remote control. The
available operations are as follows:
• Selecting the input source
of
Zone
2.
• Tuning into FM
or
AM when "TUNER" is selected as
the input source
of
Zone 2 (see page 53).
• Tuning into XM Satellite Radio when
"XM"
is selected
as the input source
of
Zone 2 (see page 57) (U.S.A. and
Canada models only).
• Tuning into SIRIUS Satellite Radio when "SIRIUS" is
selected as the input source
of
Zone 2 (see page 62)
(U.S.A. and Canada models only).
Enjoying music stored on your iPod stationed in a
Yamaha iPod universal dock (such as YDS-IO sold
separately) connected to the DOCK terminal
of
this
unit when "V-AUX" is selected as the input source
(see page 68).
fl~l~
You
must complete each step while the ZONE2 indicator
is
flashing
in
the front panel display. Otherwise, the Zone 2 mode
is
automatically canceled and this unit returns to the normal
operation mode.
In
this case, repeat the Zone 2 selection
procedure.
104 En
• Controlling
Zone
2
with
the
front
panel
Turning on Zone 2
Press
(DZONE CONTROL to turn on Zone 2.
Activating the Zone 2 operation mode
Press
(DZONE CONTROL to control Zone 2.
The ZONE2 indicator flashes in the front panel display for
approximately 10 seconds.
".
:
....
-----
ZONE2
.....
.....
;
.....
Flashes