Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Features
- HDMI Information
- Supplied Accessories
- Parts & Controls
- Connections
- Getting Started
- Basic Operation
- Advanced Setup / Menu Operation
- Remote Control Operation
- Troubleshooting
- Glossary
- Specs
- Remote Control Codes
- Index
- Correction to Manual
- Front Panel Diagram
- Remote Control Diagram
- XM Channel Guide
- Warranty
Advanced
setup
This unit has additional menus that are displayed in the front panel display. The advanced setup menu offers additional
operations to adjust and customize the way this unit operates. Change the initial settings (indicated in bold under each
parameter) to reflect the needs
of
your listening environment.
• The settings you make are reflected next time you press
®MAIN
ZONE ON/OFF to turn on this unit (see page 29).
• Only
®MAIN
ZONE ON/OFF, (OSYSTEM OFF, @TONE CONTROL and the @PROGRAM selector are effective while you
are using the advanced setup menu.
• No other operations can be made while you are using the advanced setup menu.
• The advanced setup menu is only available in the front panel display.
1 Press
©SYSTEM
OFF on the front panel to
set this unit to the standby mode.
2 Press and hold
@TONE
CONTROL and
then press
@MAIN
ZONE
ON/OFF to turn
on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
• Speaker impedance
SP
H1P.
Use this feature to set the speaker impedance
of
this unit
so that it matches that
of
your speakers.
Choices:
an
MIN,
6nMIN
• Select
"8nMIN"
to set the speaker impedance to 8
n.
• Select
"6nMIN"
to set the speaker impedance to 6
n.
If you use one set
(A
or B),
the impedance
of
each
speaker must
be 8 n or
higher.
Front
TONE
CONTROL
While holding
down
~
8nMIN
If you use two sets
(A
and
B), the impedance
of
each
speaker must
be
16
n or
higher.'
Center
Surround
Surround
3 Rotate the @PROGRAM selector
to
select
the parameter you want to adjust.
The name
of
the selected parameter appears in the
front panel display.
I I
Currently selected Currently selected
parameter parameter setting
4 Press
@TONE
CONTROL repeatedly
to
change the selected parameter setting.
5 Press
©SYSTEM
OFF to save the new
setting and set this unit to the standby mode.
6nMIN
J-------
The impedance ofeach
speaker must be 8 n or
J-------
higher.
Surround back
If you use one set (A or
B),
the impedance of each
speaker must
be 4 n or
higher.
Front
If you use two sets (A and
B),
the impedance
of
each
speaker must
be 8 n or
higher.
Center
J-------
The impedance
of
each
speaker must
be 6 n or
1--
higher.
Surround back
~*~
The settings you made are reflected next time you turn on
this unit.
106 En
, The Canada model cannot use two separate speaker systems
(A and B) simultaneously when
"SP
IMP." is set to
"SnMIN".