Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Features
- HDMI Information
- Supplied Accessories
- Parts & Controls
- Connections
- Getting Started
- Basic Operation
- Advanced Setup / Menu Operation
- Remote Control Operation
- Troubleshooting
- Glossary
- Specs
- Remote Control Codes
- Index
- Correction to Manual
- Front Panel Diagram
- Remote Control Diagram
- XM Channel Guide
- Warranty
Advanced
setup
See page 106 for the operation
of
the advanced setup.
• Remote
control
AMP
10
REt10TE
Rt'1P
Use this feature to set the AMP ID
of
this unit for remote
control recognition. This feature is useful when you
operate this unit and the other Yamaha receivers/
amplifiers
in
the same room separately.
Choices:
101.
102
• Select "IDI" when the remote control AMP
10
code is
set to "5019".
• Select "ID2" when the remote control AMP
10
code is
set to "5020".
Setting remote control AMP
10
codes
You
need to set the remote control AMP
10
code for the
remote control.
• Remote control TUNER
10
REt'lOTE
TU
Use this feature to set the TUNER
10
of
this unit for
remote control recognition.
Choices:
101,
102
• Select "IDI" when the remote control TUNER
10
code
is set to "5007".
• Select
"102"
when the remote control TUNER
10
code
is set to "5016".
Setting remote
control
TUNER
10
codes
You
need to set the remote control TUNER ID library
code for the remote control.
1 While pressing and holding
@TUNER
on
the
remote control, press
®AV
POWER for
more than 3 seconds.
@AMP flashes twice.
ID2
IDI
(initial setting)
POWER
~
Press
for
3
seconds
-.~.,
"0"
~~.
*'!'
~,~
f1as'hes
+
To
operate this unit using
an
alternative code.
5016
While holding
down
5007
To
operate this unit using
(initial setting) the default code.
*'
The remote control setting
*2 The setting
of
this unit
Press
the
numeric
buttons
(@)
to
enter the
code number "5007"
or
"5016".
When the setting succeeds. @AMP flashes twice;
however, when it does not, @AMP flashes
repeatedly.
2
IDI
(initial setting)
POWER
~
Press
for
3
seconds
+
flashes
While holding
down
5019
To
operate this unit using
(initial setting) the default code.
1 While pressing and
holding
@AMP
on
the
remote control, press
®AV
POWER for
more than 3 seconds.
@AMP flashes twice.
2 Press
the
numeric
buttons
(@)
to
enter
the
code
number
"5019"
or
"5020".
When the setting succeeds. @AMP flashes twice;
however, when it does not, @AMP flashes
repeatedly.
5020
To
operate this unit using
an
alternative code.
ID2
*1
The remote control setting
*2
The setting
of
this unit
•
107
En