Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Features
- HDMI Information
- Supplied Accessories
- Parts & Controls
- Connections
- Getting Started
- Basic Operation
- Advanced Setup / Menu Operation
- Remote Control Operation
- Troubleshooting
- Glossary
- Specs
- Remote Control Codes
- Index
- Correction to Manual
- Front Panel Diagram
- Remote Control Diagram
- XM Channel Guide
- Warranty
Troubleshooting
A source cannot
be
The source component is not connected to Connect the source component to the DIGITAL 21, 23
recorded by a digital the DIGITAL INPUT jacks
of
this unit. INPUT jacks.
recording component
Some components cannot record Dolby
connected
to
the
Digital
or
DTS sources.
DIGITAL OUTPUT
Jack.
A source cannot be The source component is not connected to Connect the source component to the analog AUDIO 23
recorded by an analog
the analog AUDIO
IN
jacks
of
this unit.
IN
jacks.
component connected
XM Satellite Radio and SIRIUS Satellite
to the AUDIO
OUT
Radio signals are not output at the AUDIO
(RECl
Jacks.
OUT
(REC) jacks.
The
sound field
"MEMORY GUARD" in "SET MENU" is Set "MEMORY GUARD" to
"OFF'.
97
parameters and some set to "ON".
other settings
of
this
unit cannot
be
changed.
This unit does not
The internal microcomputer has been Disconnect the power cable from the
AC
wall outlet
operate properly.
frozen by an external electric shock (such and then plug it
in
again after about 30 seconds.
as lightning
or
excessive static electricity)
or
by a power supply with low voltage.
No sound Is heard The HDMI component does not accept the Convert the multi-channel audio signals to the
from the connected
multi-channel audio signals. 2-channel audio signals at the source component such
HDMI component.
as a DVD player.
"CHECK SP WIRES"
Speaker cables are short-circuited. Make sure all speaker cables are connected correctly.
14
appears in the front
panel display.
There is noise
This unit is too close to the digital
or
high- Move this unit further away from such equipment.
interference from
frequency equipment.
digital or radio
frequency equipment.
The picture is
The video source uses scrambled
or
disturbed. encoded signals to prevent dubbing.
This unit suddenly
The internal temperature is too high and the Wait about I hour for this unit to cool down and then
enters the standby overheat protection circuitry has been
tum
it
back on.
mode.
activated.
• HOMI
No
picture
or
sound.
The number
of
the connected HDMI
components
is
over the limit.
Reduce the number
of
the connected HDMI
components.
HDCP authentication failed.
Check that the connected HDMI components support
the HDCP copy protection standards.
112
En