Owner's Manual

Troubleshooting
SIRIUS Satellite Radio
If
an operation takes longer than usual or an error occurs, one
of
the following messages may appear in the front panel
display. In this case, read the cause and follow the corresponding remedies.
HtHEt'U'~H
ERROR
CHECK
SR
TUt'~ER
t'~OT
SUPPORTED
HCG!U
I RI
t·j(J
UPDRTlt·Ki
F/I.J
UPDi=lT
I
t·j(J
CRLL
SI
I'~
I
US
(C~LL
:3:3:3-53
1
3-
SIRIUS
TO
SUBSCRIBE)
SUB
UPDRTED
t'k,t
Rva i 1ab1
t?
The antenna is not connected to the
SiriusConnect tuner properly.
The SiriusConnect tuner is not connected
to the SIRIUS jack
of
this unit correctly.
The SiriusConnect tuner is not connected
to the
AC
wall outlet.
This unit does not support the connected
SIRIUS Satellite Radio tuner.
The signal is too weak.
The SiriusConnect tuner
is
updating the
channel list.
The period
of
the subscription
is
end.
The SiriusConnect tuner is updating the
firmware.
The selected channel
is
not subscribed.
The subscription information is updated.
The selected channel
is
currently out
of
service.
The operation you made is not available.
Check the connection
of
the antenna and
SiriusConnect tuner.
Check the connection
of
the SiriusConnect tuner and
this unit.
Connect the power cable
of
the SiriusConnect tuner to
the
AC
wall outlet.
Connect the SiriusConnect tuner that this unit
supports,
Adjust the orientation
of
the antenna
of
the
SiriusConnect tuner. Use the "ANTENNA INFO"
information in the front panel display or "SIRIUS
Information" screen in the video monitor to check the
antenna reception level.
Wait until the updating is complete.
Contact SIRIUS Satellite Radio to renew the
subscription.
Wait until the updating
is
complete.
Contact SIRIUS Satellite Radio to subscribe the
selected channel.
URL: https://activate.siriusradio.com/
Phone: 1-888-539-SIRIUS (1-888-539-7474)
Select another channel.
Select another channel.
62
62
62
62
62,67
63
63
63
63
Remote control
The remote control
does not work nor
function properly.
Wrong distance or angle.
Direct sunlight
or
lighting (from an
inverter type
of
fluorescent lamp, etc.) is
striking the remote control sensor
of
this
unit.
The batteries are weak.
The remote control code
is
not correctly
set.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
The remote control functions within a maximum
range
of
6 m (20
ft)
and no more than 30 degrees off-
axis from the front panel.
Reposition this unit.
Replace all batteries.
Set the remote control code correctly using "List
of
remote control codes" at the end
of
this manual.
Try setting another code for the same manufacturer
using "List
of
remote control codes" at the end
of
this
manual.
31
4
102
102
115
En