Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Features
- HDMI Information
- Supplied Accessories
- Parts & Controls
- Connections
- Getting Started
- Basic Operation
- Advanced Setup / Menu Operation
- Remote Control Operation
- Troubleshooting
- Glossary
- Specs
- Remote Control Codes
- Index
- Correction to Manual
- Front Panel Diagram
- Remote Control Diagram
- XM Channel Guide
- Warranty
4 Press
@<l
II>
to
select the desired setting
for "EXTRA
SP
ASSIGN" and then
press@'ij.
Extra speaker assignment
E::·nRA
SP
ASS
I
I3t·~
Selects the function
of
the speakers connected to the
EXTRA SP tenninals.
Choices: FRONT B, ZONE2, ZONE B,
PRESENCE, NONE
• When you use the alternative
front
speaker
system (see page 43)
Select "FRONT B".
• When you use the Zone 2 speakers (see
page
104)
Select "ZONE2" to set the function
of
the speakers
to the Zone 2 speakers. This unit drives the Zone 2
speakers by using the internal amplifier.
• When you want
to
use another
front
speaker system in Zone B
Select "ZONE B".
• When you use the presence speakers (see
page 13)
Select "PRESENCE" to set the function
of
the
speakers to the presence speakers.
• When you
do
not
use the EXTRA
SP
terminals
Select "NONE" to deactivate the EXTRA SP
terminals.
If you select "ON" in "BI-AMP" (see page 109), you cannot
select "PRESENCE" or "ZONE2" in "EXTRA SP ASSIGN".
5 Press
@<l
II>
to
select "SETUP" and then
press@'ij.
Choices:
AUTO,
RELOAD, UNDO, DEFAULT
• Select "AUTO" to automatically run the entire
"AUTO SETUP" procedure.
• Select "RELOAD" to reload the last "AUTO
SETUP" settings and override the previous
settings.
• Select "UNDO" to undo the last "AUTO SETUP"
settings and restore the previous settings.
• Select "DEFAULT' to reset the "AUTO SETUP"
parameters to the initial factory settings.
OptimIzing
the
speaker
setting
for
your
Ilslenlng
room
(YPAOj
• "RELOAD" or "UNDO" is available only when you have
previously run "AUTO SETUP" and confirmed the results.
• "RELOAD" or "UNDO"
is
not available when you change
the setting
of
"BI-AMP"
in
the advanced setup (see
page 109) or "EXTRA
SP
ASSIGN"
in
"BASIC MENU"
(see page 85).
6 Press
@<l
II>
to
select the desired setting
of
"EO".
Parametric equalizer type
EG!
Parametric equalizer adjusts the level
of
the specified
frequency bands. This unit automatically selects the
crucial frequency bands for the listening room and
adjusts the level
of
the selected frequency bands to
create a cohesive sound field in the room.
You
can
select the type
of
the parametric equalizer adjustment
from the following choices.
Choices: NATURAL, FLAT, FRONT
• Select "NATURAL" to average out the frequency
response
of
all speakers with higher frequencies
being all speakers to achieve more natural sound.
Recommended
if
the FLAT setting sounds a little
harsh.
• Select
"FLAT'
to average the frequency response
of
all speakers. Recommended
if
all
of
your
speakers are
of
similar quality.
• Select "FRONT" to adjust the frequency response
of
each speaker in accordance with the sound
of
your front speakers. Recommended
if
your front
speakers are
of
much higherquality than your other
speakers.
33
En
•