Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Features
- HDMI Information
- Supplied Accessories
- Parts & Controls
- Connections
- Getting Started
- Basic Operation
- Advanced Setup / Menu Operation
- Remote Control Operation
- Troubleshooting
- Glossary
- Specs
- Remote Control Codes
- Index
- Correction to Manual
- Front Panel Diagram
- Remote Control Diagram
- XM Channel Guide
- Warranty
Playback
Before perfonning the following operations,
press@AMPon
the remote control.
This unit comes with a variety
of
input jacks. Use this
feature (audio input
jack
select) to switch between input
jacks when more than one input
jack
is
assigned to the
same input source.
You
can display the operating information
of
this unit on a
video monitor.
1 Turn on the video monitor connected
to
this
unit.
2 Press
~DISPLAY
on the remote control.
The current status screen appears in the OSD.
•
We
recommend that you set the audio input
jack
select to
"AUTO" in most cases.
•
You
can adjust the default audio input jack select
of
this unit
by
using "AUDIO SELECT" in
"OPTION
MENU"
(see page 98).
snnus
UOL:
-40.
0cJB
r'10UIE
Sci-Fi
HlPUT:
DUD
~.SEU
HDtH
Press
@AUDIO
SELECT
(or
@AUDIO
SEL)
repeatedly
to
select the desired audio
input
jack
select setting.
Available Input sources
I
'UlUX
OTV,ca..DYO
XM
llIIUII
[DISPL~Yl:ST~TUS
OFF
,0,
~ti>~
•
You
can select the amount
of
time that the current status is
displayed in the
OSO
by using the
"OSO-AMP"
parameter
in "OPTION
MENU"
(see page 96).
• To
tum
off
the status screen, press
~DISPLAY
again.
H
-
'-E"
•
, •
-.
.L •
!=IUTO,
I
Currently selected audio Input jack select setting
The OSO signal is not output at the
OVR
and VCR VIDEO
OUT
jacks and will not be recorded.
AUTO
HDt01I
COA::'~/OPT
Automatically selects input signals
in
the
following order:
(I)
HDMI
(2) Digital signals
(3) Analog signals
Selects only HDMI signals. When
HDMI
signals are not input,
no
sound is output.
Automatically selects input signals
in
the
following order:
(I)
Digital signals input at the COAXIAL
jack
(2) Digital signals input
at
the OPTICAL
jack
When
no
signals are input, no sound
is
output.
Selects only analog signals. If
no
analog
signals are input,
no
sound is output.
This feature is not available when no digital input jacks
(OPTICAL, COAXIAL and HOMI) are assigned. In addition,
HOMI is not available as an audio input jack select setting when
the HOMI IN jacks are not used. Use "I/O ASSIGNMENT" in
"INPUT
MENU"
to reassign the respective input
jack
(see
page 93).
44 En