Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Features
- HDMI Information
- Supplied Accessories
- Parts & Controls
- Connections
- Getting Started
- Basic Operation
- Advanced Setup / Menu Operation
- Remote Control Operation
- Troubleshooting
- Glossary
- Specs
- Remote Control Codes
- Index
- Correction to Manual
- Front Panel Diagram
- Remote Control Diagram
- XM Channel Guide
- Warranty
Playback
You
can display the audio and video infonnation
of
the
current input signal.
"---"
appears
when
this unit
cannot
display
the
corresponding
information.
• Video information
1
Press@AMPandthen
press@MENU
on
the remote control.
The top "SET MENU" display appears in the OSD.
SET
t'IENU
..
·~UTO
SETUP
•
t'l~NU~L
SETUP
·SI6N~L
HIFO
[ ...
]/[.,.]:
Up/Dmm
[ENTER]:
Er,ler
2 Press
@V
repeatedly to select "SIGNAL
INFO" and then
press@ENTER.
The audio infonnation about the input source appears
in theOSD.
HDM
I SI
Gt'1~L
HDMI
RES.
~1'1~LOG
RES.
HDMI
ERROR
(HDMI
MESS~GE)
Type
of
the source video signals and
the video signals output at the HDMI
OUT
jack
of
this unit.
Resolution
of
the input signal (analog
or
HDM!) and the output signal
(HDM!). When input video signals are
composite video or S-video signals,
the input video signals are indicated as
"Composite" or "S-Video".
Resolution
of
the analog video signals
output at the COMPONENT VIDEO
MONITOR OUTjacks
of
this unit.
Error message for HDMI sources or
connected HDMI devices.
3 Press
@<l/
[>
to toggle between the audio
and video information displays.
4 Press
@MENU
on the remote control again
to exit from "SET MENU".
.
Nofil
"---"
appears when this unit
cannot
display
the
corresponding
information.
HOMI error and message
• Audio information
DEVICE
OVER
The number
of
the connected HDMI
components is over the limit.
FOR~l~T
S~~lPL
I
1·1G
CH~I·n·1EL
8ITR~TE
FL~G
46 En
Signal format. When this unit cannot detect a
digital signal, it automatically switches to
analog input.
The number
of
samples per second taken from
a continuous signal to make a discrete signal.
The number
of
source channels in the input
signal (front/surroundILFE). For example, a
multi-channel soundtrack with 3 front
channels, 2 surround channels and LFE, is
displayed as "3/2/0.1".
The number
of
bits passing a given point per
second.
Flag data encoded
in
DTS, Dolby Digital, or
PCM signals that cue this unit to automatically
switch decoders ("Surround EX", etc.).
HDCP
ERROR
Out
of
Res.
HDCP authentication failed.
Out
of
resolution. The connected monitor is
not compatible with the resolution
of
the
input video signal.