Owner's Manual

Before performing the following operations, press @TUNER
on the remote control.
• Automatic station preset
You can use the automatic preset tuning feature to store up
to 40 FM stations with strong signals (AI to E8: 8 preset
station numbers in each of the 5 preset station groups) in
order.
1 Rotate the ®INPUT selector (or press
@TUNER) to select "TUNER" as the input
source.
2 Press ©BAND (or CVBAND) to select "FM"
as the reception band.
"FM" appears in the front panel display.
3 Press and hold ®MEMORY (or
®MEMORy) for more than 3 seconds.
The preset station number as well as the MEMORY
and AUTO indicators flashes. After approximately 5
seconds, automatic presetting starts from the current
frequency and proceeds toward higher frequencies.
Flash
...:. .
_' ~TO .....
.
L..-
1
R.l
l
: Ft'1 ::::::. '3t'1Hz
Flashes
When automatic preset tuning is completed, the
MEMORY indicator disappears.
• You can specify the preset number from which this unit stores
FM stations. Press@AlB/CIDIE
(or@A-ElCAT. <l It» and
then
@PRESETITUNINGICH <l I t>
(or@PRESET/CH IJ. I 'i/) repeatedly after you perform step 3
to select the preset station number under which the first station
will be stored.
•
To cancel the automatic station preset, press ®MEMORY (or
@MEMORY)again.
;No~"""ij
'0,,,.
• Any stored station data existing under a preset station number is
cleared when you store a new station under the same preset
station number.
• If the number of received stations does not reach 40 (E8),
automatic preset tuning automatically stops after searching for
all the available stations and copy the stored stations to the rest
preset station numbers.
• Only FM stations with sufficient signal strength are stored
automatically by automatic preset tuning.
If the station you
want to store is weak in signal strength or an
AM radio station,
tune into it manually and store it as described in "Manual
station preset" below.
FM/AM tunmg
• Manual station preset
Use this feature to store the AM or FM stations with weak
signals manually.
1 Tune into a station.
See page 53 for tuning instructions.
2 Press ®MEMORY (or ®MEMORy).
The MEMORY indicator flashes in the front panel
display for approximately 30 seconds.
-'. : .-"
.. ... MEMORy·····
Flashes
:\4{-:.
To cancel the preset memory mode, press ®MEMORY (or
@MEMORY) again.
3 Press @PRESETITUNING/CH <J / t> (or
@PRESET/CH /::./ 'I) repeatedly to select a
preset station
group and number (Al to E8)
while the MEMORY indicator is flashing.
• Press @t> (or @/::.) to select a higher preset
station group and number.
• Press@<J (or@'i/) to select a lower preset station
group and number.
Flashes
I
"'T
The displayed station has been stored as A1.
,:-\et':.
You can select the preset station group (A to E) by pressing
@AlB/CID/E (or@A-ElCAT. <l I t» repeatedly.
4 Press ®MEMORY (or ®MEMORy) while
the MEMORY
indicator is flashing.
The station band and frequency appear in the front
panel display with the preset station group and
number you have selected. The MEMORY indicator
disappears from the front panel display.
• Any stored station data existing under a preset station number is
cleared when you store a new station under the same preset
station number.
• The reception mode (stereo or monaural)
is stored along with
the station frequency.
55 En
•