Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Features
- HDMI Information
- Supplied Accessories
- Parts & Controls
- Connections
- Getting Started
- Basic Operation
- Advanced Setup / Menu Operation
- Remote Control Operation
- Troubleshooting
- Glossary
- Specs
- Remote Control Codes
- Index
- Correction to Manual
- Front Panel Diagram
- Remote Control Diagram
- XM Channel Guide
- Warranty
Before performing the following operations, press
@XM.
• All Channel Search mode
1 Press
@SEARCH
MODE
(or
@SRCH
MODE)
repeatedly to select"ALL CH
SEARCH".
2 Press
@PRESETITUNING/CH
<J
/
[>
(or
@PRESET/CH
11/
'V)
repeatedly to search
for a channel within all channels.
~.,~
•
You
can search for a channel quickly by pressing and holding
@PRESETITUNINGICH
<J!
C> (or@PRESET/CH /J.! 'if).
•
To
display the
XM
Radio
ID
number displayed
in
the front
panel display, select channel
"Q".
• Category Search mode
1 Press
@SEARCH
MODE
(or
@SRCH
MODE)
repeatedly to select "CAT SEARCH".
2 Press
@CATEGORY
(or @A-E/CAT.
<J
/
[»
repeatedly to change the channel category.
3 Press
@PRESETITUNING/CH
<J
/
[>
(or
@PRESET/CH
11/
'V)
repeatedly to search
for a channel within the selected channel
category.
~,¥-:.
You
can search for a channel quickly by pressing and holding
@PRESETITUNINGICH
<J!
C> (or @PRESET/CH /J.! 'iI).
XM
Satellite
Radio
tUning
• Preset Search mode
Prior to selecting a preset channel
in
the Preset Search
mode, you must preset XM Satellite Radio channels. For
details, see "Setting the XM Satellite Radio preset
channels" on page 60.
~\.-:.
The initial factory setting
of
all preset channels (AI to E8)
is
"00
I
Preview".
1 Press
@SEARCH
MODE
(or
@SRCH
MODE)
repeatedly to select "PRESET
SEARCH".
2 Press
@CATEGORY
(or @A-E/CAT.
<J
/
[»
repeatedly to change the preset channel
group (A to E).
3 Press
@PRESETITUNING/CH
<J
/
[>
(or
@PRESET/CH
11/
'V)
repeatedly to change
the preset channel number
(1
to 8).
You
can also select the preset channel number directly by
pressing the numeric buttons
(I
to
8)
(@).
• Direct number access mode
1
Press@SRCH
MODE
on the remote control
repeatedly to select"ALL
CH
SEARCH" or
"CAT SEARCH".
2 Press the numeric buttons
(@)
to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons
(@)
as shown below.
,I,
~<iI:'
•
To
enter a one-digit or two-digit channel number, press the
numeric buttons
(@)
on the remote control and then press
@ENTtoconftnn the input number.
• Instead
of
pressing
@ENT
to tune into the channel
immediately, you can wait a few seconds until this unit conftnns
the entered channel number.
• Pressing a button other than the numeric buttons
(@)
or
@ENT
cancels the Direct Number Access mode procedure.
59
En
•