Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Features
- HDMI Information
- Supplied Accessories
- Parts & Controls
- Connections
- Getting Started
- Basic Operation
- Advanced Setup / Menu Operation
- Remote Control Operation
- Troubleshooting
- Glossary
- Specs
- Remote Control Codes
- Index
- Correction to Manual
- Front Panel Diagram
- Remote Control Diagram
- XM Channel Guide
- Warranty
Use this menu to adjust the parameters
of
each input
source.
4 I
~IPUT
HEt·jU
1/2
4
HlPUT
t'1ENU
2/2
..
A)
SIRIUS
..
H)
U-AUX
B)
XI'l
J)
DOCK
C)
TUNER
J)
BLUETOOTH
D)
CD
K)
DlJR
E)
t'lD/CD-R
U
UCR
F)
DUD
t'D
t1UL
TI
CH
G)
DT~VCBL
[a]/
[T]:
Up/Do,Jn
[a]
/
[T]:
Up/Down
[ENTER):
Enter
[ENTER]:
Enter
Customizing
this
umt
(MANUAL
SETUP)
Input/output assignment
I/O
RSS
113t·U1EtH
Use this feature to assign the input/output jacks according
to the component to be used if the initial settings
of
this
unit do not correspond to your needs. Change the
parameter to reassign the respective jacks and effectively
connect more components.
Once the input/output jacks are reassigned, you can select
the corresponding component by using the
@INPUT
selector on the front panel (or the input selector buttons on
the remote control).
A)SIRIUS
(U.S.A. and Canada
models only)
B)XM
(U.S.A. and Canada
models only)
C)TUNER
M)MULTICH
D)CD
E)MD/CD-R
F)DVD
G)DTV/CBL
H)V-AUX
K)DVR
L)VCR
I)DOCK
J)BLUETOOTH
INPUT RENAME
VOL. TRIM
PARENTAL LOCK
INPUT RENAME
VOL. TRIM
INPUT RENAME
VOL. TRIM
INPUT RENAME
VOL. TRIM
BGV
INPUTCH
FRONT
INPUT RENAME
VOL. TRIM
DECODER MODE
INPUT RENAME
VOL. TRIM
STANDBY CHARGE
INPUT RENAME
VOL. TRIM
START PAIRING
K)
DIJR
..
COMPONENT
IN···[B]"
COAXIAL
IN····NONE
OPTICAL
IN····NONE
HDMI
IN········[3]
Current(
DTU/CBL
)
[
...
]/[~]:
Select
[EtHER]:
Enter
• "NONE" appears in the OSD when any input source
is
not
assigned
to
the input/output jack.
•
You
cannot select a specific item more than once for the same
type
of
jack.
• An asterisk
(*) appears
to
the right
of
the input/output jack
names that have been changed from their previous settings.
• The currently assigned input source for the selected input/
output jack appears in the OSD ("Current(
DTV/CBL)"
in the
display example above).
ilfit41
Some parameters described above may not be available for all
input sources and some parameters are only available for specific
input sources.
93 En
I