Owner`s manual

5-11
ESU00035
Parking brake lever
When parking the snowmobile or starting the engine,
apply the parking brake by moving the brake lever
1
to
the left.
To release the parking brake, move the parking brake
lever
1
to the right.
È
To apply the parking brake
É
To release the parking brake
WARNING
@
●
Always set the parking brake before attempting to
start the engine.
●
Never run the snowmobile with the parking brake
applied. This may overheat the brake disc and
reduce braking ability.
@
ESU00341
Shift lever
For RX10R/RX10RS/RXW10/RXW10S
The shift lever is used to put the snowmobile into forward
or reverse. After coming to a complete stop, pull the shift
lever out, slide it to “FWD” or to “REV” until it stops, and
then release it.
1
Shift lever
2
Pull out
3
Slide to “FWD” (Forward)
4
Slide to “REV” (Reverse)
5
Release
CAUTION
:
@
Do not shift from “FWD” to “REV” or from “REV” to
“FWD” while the snowmobile is moving. Otherwise,
the drive system could be damaged.
@
A
B
U8FU10.book Page 11 Thursday, April 8, 2004 6:27 PM