Owner`s manual

8-28
For RX10M/RX10MS/RXW10/RXW10S
1. Loosen the locknut
1
.
2. Turn the control rod adjusting nut
2
in direction
a
to
increase weight transfer or direction
b
to decrease
weight transfer.
3. Tighten the locknut while holding the adjusting nut in
place.
CAUTION
:
@
●
When using the two wrenches included in the
owner’s tool kit, make sure that they are situated
at a right angle to the control rod as shown, and
that they are tightly fitted to the locknut and the
control rod adjusting nut.
●
The left and right adjusting nuts must be set to
the same position. Uneven settings can cause
poor handling and loss of stability.
@
WARNING
@
Never adjust the control rods beyond the maximum
range indicated on the rods with red paint 3.
@
c
Adjustable range
d
Standard position
È
RX10M/RX10MS
É
RXW10/RXW10S
A
A
B
B
Locknut tightening torque:
25 Nm (2.5 m·kgf, 18 ft·lb)
E_8fu_Periodic.fm Page 28 Thursday, April 15, 2004 11:26 AM