Operation Manual

ASSIGNING A SWING FACTOR TO THE PATTERN

- Hold [MODE] and press

[PAGE-] or [PAGE+] once or more to access the Swing function. The word

“SWING” will appear in the LCD, as will the current Swing setting (OFF, E1 ~

E9, S1 ~ S5). To assign a Swing factor to the currently selected pattern,

press [-1] or [+1]. The Swing setting also affects the backing accompaniment.

When a Swing setting is assigned to a pattern, whenever the pattern is

selected, the word “SWING” will appear in the upper area of the LCD.

There are two types of Swing factors. “E” factors represent 8-beat, and “S” factors represent 16-beat.

Depending on the selected Swing type or selected patterns, the Swing function may not produce an

apparent effect.

CLEARING A USER PATTERN

-When the pattern is stopped, hold [MODE]

and press [PAGE-] or [PAGE+] to access the Pattern Clear function. The words

“CLEAR SURE?” will appear in the LCD. Press [-1] and [+1] to select a User

pattern number (#200 ~ #249). Then, press [ENTER] to clear the data from

the pattern. The word “EMPTY” will appear beside the pattern number in the

LCD. (To exit the Clear function, hold [MODE] and press [PAGE-].)

If the word "PRESET" temporarily appears in the LCD when you press [ENTER], this means you are

attempting to clear a Preset pattern. If this happens, simply select a User pattern number (#200 ~

#249) and try again.