User Manual

S90 XS/S70 XS Remote Editor Windows: Edit window
S90 XS/S70 XS Remote Editor Owner’s Manual
8
7 Control Template Selection box
Shows the currently selected Control Template. You can select the previous/next template by clicking the
scroll button at the right of this box, or select any template in the current bank by clicking the triangular
button.
8 Instrument Select box
Shows the VSTi name which is controlled by the Knobs and Sliders. You can change the VSTi by clicking
the triangular button then selecting the desired one. You can also input the VSTi name directly in this box
manually. Make sure to input the VSTi name correctly.
n If the desired VSTi is not shown even when you click the triangular button, refer to the Troubleshooting
section on page 14.
9 Edit section
The Knobs and Sliders illustrated here correspond to the Knobs and Sliders on the top panel of the S90
XS/S70 XS. Here, you can assign the desired function to each of the Knobs and Sliders.
9-1 Remote/CC buttons
When Remote is selected, using the Knobs and Sliders generates the Remote Control messages
exclusive for Cubase. When CC is selected, using the Knobs and Sliders generates MIDI Control
Change messages.
9-2 Function Assignment boxes
The Knobs and Sliders illustrated here are equivalent to the Knobs and Sliders on the S90 XS/S70
XS. Each of the boxes at the right side of the Knob and Slider shows the function assigned to the
corresponding Knob and Slider. (The function shown here differs depending on the Remote/CC
button status.) You can change the function assigned to each of the Knobs and Sliders by clicking
a desired box, then selecting the desired function in the ) Controller Setting section. In the
ONLINE status, setting this parameter changes the settings of the S90 XS/S70 XS in real time.
9-3 [Reverse] button
Reverses the direction of the Slider operation, determining whether moving the Slider up or down
increases or decreases the value. For example, when a parameter which is increased by moving
the Slider up is assigned to a Slider and this button is turned on, moving the Slider up decreases
the parameter value. Clicking the button once again restores the original state.
) Controller Setting section
Determines the function of the Knobs and Sliders corresponding to the column selected in the 9 Edit
section. There are two sections here: Remote section and CC (Control Change) section.
)-1 Remote section
Assigns the function to the Function Assignment box selected in the 9 Edit section. The setting
here is available when the Remote/CC button is set to "Remote." Clicking "Remote" at the left of this
section also sets the Remote/CC button of the Edit section to "Remote.
• Control Parameter
Click the triangular button to call up the menu, then select the desired function.
n The "QuickCtrl1" – "QuickCtrl8" parameters only apply to Cubase 4.1 or later.