Owner's Manual

Page 60/112 GEO S12 HARDWARE SETUP PROCEDURE
To facilitate flying operation, an optional link bar with oblong holes (GEOS12-TLB, pair of link bars
provided with two 8x20 quick release pin) is available in the GEO S12 accessory range.
GEO S12 X-BOW OPTIONAL GEOS12-TLB LINK BAR
To install GEOS12-TLB, remove the standard link as well as nut, screw and washers.
When using GEO S12 XBOW for flown setups, insert pins in the oblong hole and opposite circular hole.
REMOVING STANDARD LINK BAR INSERTING PIN - FLOWN SETUPS
Procedure
• Insert GEOS12-XBOW-V2 into connecting plates of both sides of the cabinet;
• Lock safety pins into GEO S12s connecting plate