Owner's Manual

GEO S12 HARDWARE SETUP PROCEDURE Page 61/112
051015 -5 -10
-15
IMPORTANT
Ensure that safety pins are properly locked into GEO S12s connecting panels.
IMPORTANT
GEO S12 can be flown “Left” or “Right” :
- “Left” means Nexo logo on front grid is left as seen from front;
- “Right” means Nexo logo on front grid is right as seen from front.
GEO S12 can be connected to bumper “Left” or “Right” by simply flipping the cabinets.
Whenever possible, NEXO recommends symmetrical designs (preferably NEXO logo
outwards in stereo configurations)
• Connect bumper to first GEO S12 using “lift” points of GEO S12 X-Bows; ensure quick release
pins are properly locked;
• Insert axis in bumper Geosoft2 predefined hole and secure it with provided “R” clip;
NB: Bumper holes are numbered #-17 to #17, please refer to Geosoft2 to determine axis
position in relation to bumper angle requirements.
If bumper is flown with 2 hoists, then they should be connected to holes #-17 and #17.
• Connect hoist hook to bumper axis and lift assembly to sufficient height in order to connect a
second GEO S12;
• Connect second Geo S12 with X-Bow front articulation holes and rear link bars and ensure quick
release pins are properly locked;
• Repeat above steps for subsequent GEO S12’s