Owner's Manual

Page 36/112 GEO S12 HARDWARE SETUP PROCEDURE
8.2.2 WARNINGS ON GEO S12 ACCESSORIES
WARNING 1T
All GEO S12 Accessories are specifically rated in agreement with structural
computations.
Never use other accessories – including push-pins - when assembling GEO S12 cabinets
than the ones provided by NEXO: NEXO will decline responsibility over the entire GEO
S12 accessory range if any component is purchased from different supplier.
WARNING 2
For SAFETY reasons, following first generation accessories:
- GEOS12-XBOW
- GEOS12-TCBRK
- GEOS12-SSBRK
- GEOS12-PSBRK
- GEOS12-TTC
Have been recalled in August 2007 and MUST NO LONGER BE USED
These accessories have been replaced by:
- GEOS12-XBOW-V2
- GEOS12-TCBRK-V2
- GEOS12-SSBRK-V2
- GEOS12-PSBRK-V2
- GEOS12-TTC-V2
Please contact your local distributor if any doubt in relation the GEO S12 accessories you
are using.
WARNING 3
All GEO S12 accessories have been designed so that cabinets are arrayed in the acoustic
coupling plane (adjacent waveguides as shown in figures below).
GEO S12 assemblies in the “non coupling plane” – as shown in figure below- are UNSAFE
and STRICTLY PROHIBITED.
YES YES NO