Owner's Manual

GEO S12 HARDWARE SETUP PROCEDURE Page 63/112
8.4.9 Ground stacked GEO S1210
Required items
• N Pair of Rigging Plates (GEOS12-XBOW-V2) for N cabinets;
• 1 ground stack device (GEOS12-GSTK);
• 4xN Quick release pins for N cabinets;
IMPORTANT
- Ground stack device GEOS12-GSTK is rated for a maximum of 6 GEO S1210s in any inter
cabinet angle configuration, provided this device is assembled according to below rules.
- Ground stack device GEOS12-GSTK must always be installed on a horizontal surface;
- Bottom GEO S12 tilt angle must be limited to +/-10°
- Ensure that public is not allowed within a safety area which radius is equal or higher
than assembly height.
Optional GEOS12-TLB link bar for GEO S12 XBOW
GEOS12-XBOW-V2s are delivered with standard link bars which allow both stacked and flown setups.
However, these link bars require perfect alignment of angle setting holes when adding cabinets.
GEO S12 X-BOW STANDARD LINK BAR
To facilitate flying and stacked operation, an optional link bar with oblong holes (GEOS12-TLB, pair of
link bars provided with two 8x20 quick release pin) is available in the GEO S12 accessory range.
GEO S12 X-BOW OPTIONAL GEOS12-TLB LINK BAR
To install GEOS12-TLB, remove the standard link as well as nut, screw and washers.
When using GEO S12 XBOW for stacked setups, insert pins in the two circular holes.
REMOVING STANDARD LINK BAR INSERTING PINS - STACKED SETUPS