Operation Manual

Operation flow from starting the application to closing it
S90 XS/S70 XS Remote Editor Owner’s Manual
4
Operation flow from starting the application to
closing it
The S90 XS/S70 XS Remote Editor is a software contained in the S90 XS/S70 XS Remote Tools. After
installing the S90 XS/S70 XS Remote Editor and related applications by following the Installation Guide of the
S90 XS/S70 XS Remote Tools, follow the instructions below. Before starting, make sure that the S90 XS/S70
XS is properly connected to the computer via a USB cable. There is no single way to use the many
components in the S90 XS/S70 XS Remote Editor. Your editing needs and preferences may differ; however,
the following example gives you a simple step-by-step guide in how to use the S90 XS/S70 XS Remote
Editor.
n After completing installation of the S90 XS/S70 XS Remote Editor, start the DAW software once then quit it. This operation
is necessary to scan through the DAW software for obtaining the VSTi-related information. Only DAW software produced
by Steinberg (such as Cubase) can be scanned.
1. Start the S90 XS/S70 XS Remote Editor by selecting [Start] → All Programs →
[Yamaha S90 XS _ S70 XS Remote Editor] → [Yamaha S90 XS _ S70 XS Remote
Editor].
The Auto Sync window appears and the settings of the 50 Control Templates on the S90 XS/S70 XS are
transferred automatically to the Current Bank (page 10) of the S90 XS/S70 XS Remote Editor.
After transfer has been successfully completed, the Edit window appears.
n If data transfer in the Auto Sync window fails even when the S90 XS/S70 XS and computer are connected
properly, make sure to set the MIDI In/Out parameter to "USB" and the Device Number parameter to "1" or
"All" in the Utility MIDI display on the S90 XS/S70 XS.