User Manual
Table Of Contents
- Welcome
- Accessories
- About the accessory disk
- S90 XS/S70 XS Main Features
- About this Manual
- Contents
- Controls and Functions
- Setting Up
- Start Guide
- Modes
- Basic Instructions
- Playing the Keyboard in the Voice mode
- Creating a New Performance by Using Your Favorite Voice (Performance Creator)
- Playing the Keyboard in the Performance Mode
- Singing with a Connected Microphone
- Recording/Playing Back with a USB Storage Device (Audio Record/Play Mode)
- Using a Connected Computer
- Playing the Keyboard Along with Playback of the MIDI File
- Using as a Master Keyboard (Master Mode)
- Making Global System Settings (Utility Mode)
- Saving/Loading Data (File Mode)
- Appendix
- Display Messages
- Troubleshooting
- No Sound
- No sound from the MIC INPUT jack
- Split does not work via the external MIDI device
- Playback continues without stopping
- The sound is distorted
- Sound is cut off
- Only one note sounds at a time
- Wrong pitch or unexpected pitch
- No effect is applied
- Vocoder does not work when selecting a Vocoder Voice
- The Edit Indicator appears, even when parameters are not being edited
- Cannot start the Arpeggio
- Cannot stop the Arpeggio
- The Voice assigned to the Performance produces a different sound from the one in the Voice mode
- Data communication between the computer and the S90 XS/S70 XS does not work properly
- The S90 XS/S70 XS does not sound properly even when playing back the song data on the computer or the MIDI instrument connected to the S90 XS/S70 XS
- MIDI bulk data transmission/reception does not work properly
- Cannot save data to the external USB storage device
- Cannot play an audio file
- Cannot enter the Edit mode
- Specifications
- Index
S90 XS/S70 XS Owner’s Manual
44
Using as a Master Keyboard (Master Mode)
3 Press the [EDIT] button.
The Master Edit Select display appears.
4
Select “Common” then press the [ENTER]
button.
The Common Edit display appears.
5
Select “Zone Sw” then press the [ENTER]
button.
The Common Zone Switch display appears.
6 Set “Zone Switch” to “on.”
The “Knob/Slider” parameter also will be set to on
automatically.
NOTE
When using the Knobs/Sliders as the controller of the Knob
Function/Slider Function, set the Knob/Slider to off.
7 Press the [EXIT] button twice to return to the
Master Edit Select display.
8 Select “Zone 1” by using the cursor buttons
then press the [ENTER] button.
The Zone Edit Select display appears.
9 Make the settings of the Zone 1 in the
respective Transmit, Note, Preset and Knb/
Sldr displays.
Transmit display
Note display
Preset display
Knob/Slider display
10 Press the [EXIT] button to return back to the
Master Edit Select display, then set the
other Zone using this same operation.
11 After setting all the desired parameters,
press the [STORE] button to store your
settings as a Master program.
After completing these settings, assign a name to the
Master in the “Name” parameter of the Master Common
Edit display. After naming, press the [STORE] button to
store the Master.