User Manual

Reference Manual
Reference
102
Voice
Performance
Multi
SEQ Play
Master
Remote
File
Audio Rec/Play
Utility
Multi
Play
Mixing
Edit Select
Common Edit
Name
Arpeggio
Controller
Effect
Parameter
Master EQ
A/D Out
A/D FX
Parameter
Part Edit
Voice
Play Mode
Arpeggio
Arp Edit
Arp 1-5 Type
Filter/EG
3 Band EQ
Rcv Sw
FX Send
Job Select
Recall
Bulk
Copy
Initialize
Basic Structure
Appendix
Volume
Adjusts the Volume for each Part. Use this parameter to adjust the balance between the current Part and other Parts.
This parameter can be changed via the Slider directly.
Settings: 0 – 127
Pan
Determines the stereo pan position for the Part. This parameter can be changed via the Slider directly.
Settings: L63 (far left) – C (center) – R63 (far right)
NOTE: Note that this Part Pan parameter may have little or no audible effect if the Pan for a specific Element of the Voice is set to the left
position and the Pan for another Element is set to the right position.
Voice Elm Pan (Voice Element Pan)
Determines whether the individual pan settings for each Element (of the Voice assigned to the selected Part) are
applied or not. When this is set to “off,” the basic pan position for the selected Part is set to center.
Settings: on, off
Assign 1 Value
Assign 2 Value
Determines the offset value by which the functions assigned to the Assign 1/2 knobs will be shifted from their original
settings. This parameter can be changed via the Knob directly.
Settings: -64 – +0 – +63
Note Shift
Adjusts the pitch of the Part in semitones.
Settings: -24 – +0 – +24
Detune
Adjusts the tuning of the Part in 0.1 Hz increments.
Settings: -12.8Hz – +0Hz – +12.7Hz
PB Range Upper (Pitch Bend Range Upper)
PB Range Lower (Pitch Bend Range Lower)
Determines the maximum Pitch Bend range in semitones. Setting the Upper parameter to +12 would result in a
maximum pitch rise of one octave when the Pitch Bend wheel is moved upwards. Similarly, setting the Lower parameter
to -12 would result in a maximum pitch down of one octave when the wheel is moved downwards.
Settings: -48semi – +0semi – +24semi
Mono/Poly
Selects whether the Voice of the Part is played monophonically (only one note at a time) or polyphonically (multiple
notes sounding simultaneously).
Settings: mono, poly
Note Limit Lo/Hi (Note Limit Low/High)
Set the lowest and highest notes of the keyboard range for each Part. Each Part will only sound for notes played within
its specified range. If you specify the highest note first and the lowest note second, for example “C5 to C4,” then the
note range covered will be “C -2 to C4” and “C5 to G8.”
Settings: C -2 – G8
NOTE: You can also set the Note directly from the Keyboard, by holding down the [SHIFT] button and pressing the desired key.
2 Play Mode
mono When set to “mono,” the selected Voice is played back monophonically (only a single note is played back simultaneously). For
many instrument sounds (such as bass and synth lead), this allows a more natural and smooth sounding legato performance than
when this parameter is set to “poly.”
poly When set to “poly,” the selected Voice is played back polyphonically (multiple notes can be played back simultaneously or a chord
is played back).