User Manual

Reference Manual
Reference
145
Voice
Performance
Multi
SEQ Play
Master
Remote
File
Audio Rec/Play
Utility
Utility
Utility Select
General
Layer/Split/
Drum Assign
MIDI
Controller
Micro Tune
Voice Select
Arpeggio
A/D Out
A/D FX
Master FX
Master EQ
Remote
Quick Set
Panel Lock
Fctry Set
Basic Structure
Appendix
Determines which buttons become unavailable when turning on the [PANEL
LOCK] button on the panel.
All (Panel Lock Section All)
Octave & Transpose (Panel Lock Section Octave and Transpose)
Number 1 – 16 (Panel Lock Section Number 1 – 16)
When the checkbox of “All” is entered, all buttons and controllers become unavailable, except for the following.
• Pitch Bend wheel
• Modulation wheel
• INPUT GAIN knob
• Master Volume slider
• Keyboard
When the checkbox of “Octave & Transpose” is entered, the OCTAVE and TRANSPOSE buttons become unavailable.
When the checkbox of “Number 1 – 16” is entered, the Number [1] – [16] buttons become unavailable.
Settings: on, off
You can restore this tone generator’s User memory (page 24) to the factory default settings (Factory Set). Please note
that the setting of the Power On Auto Factory Set on this display will be stored automatically by executing Factory Set.
CAUTION
When you restore the factory default settings, the internal flash memory as well as the internal User memory data (all the User
Voices, Multis, and system settings in the Utility you created) will be overwritten with the factory defaults. Take care so as not to
lose important data. You should back up any important data to a USB storage device as a file with the “All” type in the File mode
or a computer by using the Bulk Dump function (page 127).
Auto Factory Set (Power On Auto Factory Set)
When this parameter is set to “on,” turning the power on will restore the User memory to the factory default settings. If
you change this setting, make sure to execute the Factory Set function to finalize the change.
Settings: off, on
CAUTION
When setting Auto Factory Set to “on” and executing Factory Set, the Factory Set function will automatically be executed each
time you turn the power on. For this reason, this normally should be set to “off.”
8 Panel Lock
9 Fctry Set (Factory Set)