User Manual

Reference Manual
Appendix
150
Basic Structure
Functional Blocks
Tone Generator
A/D Input
Arpeggio
Sequencer
Audio Record/Play
Controller
Effect
Internal Memory
Reference
Voice
Performance
Multi
SEQ Play
Master
Remote
File
Audio Rec/Play
Utility
Appendix
About MIDI
Display Messages
Troubleshooting
Channel Mode Messages
All Sounds Off (Control #120)
Clears all sounds currently sounding on the specified channel.
However, the status of channel messages such as Note On and Hold On is maintained.
Reset All Controllers (Control #121)
Resets all controllers to their initial values.
The following parameters are affected:
All Notes Off (Control #123)
Clears all notes currently on for the specified channel. However, if Hold1 or Sostenuto is on, notes will
continue sounding until these are turned off.
Mono (Control #126)
Performs the same operation as when an All Sound Off message is received. If the 3rd byte parameter (the
parameter that determines the mono number) is 0 – 16, the Parts corresponding to those channels are set
to mono.
Poly (Control #127)
Performs the same function as when an All Sounds Off message is received, and sets the corresponding
channel to Poly Mode.
Program Change
Messages that determine which voice to select for each Part. With a combination of Bank Select, you
can select not only basic voice numbers, but also variation voice bank numbers.
For a list of the Voices, see the Data List (separate PDF document).
NOTE
When you specify a program change as a number in the range of 0 – 127, specify a number that is one less
than the program number listed in the Voice List. For example, to specify program number 128, you would
actually enter program change 127.
Pitch Bend
Pitch Bend messages are continuous controller messages that allow the pitch of designated notes to be
raised or lowered by a specified amount over a specified duration.
Channel Aftertouch
Messages which let you control the sounds by the pressure you apply to the keys after the initial striking
of the keys, over the entire channel.
Polyphonic Aftertouch
Messages which let you control the sounds by the pressure you apply to the keys after the initial striking
of the keys, for each individual key.
2nd BYTE 3rd BYTE MESSAGE
120 0 All Sounds Off
121 0 Reset All Controllers
123 0 All Notes Off
126 0 – 16 Mono
127 0 Poly
CONTROLLER VALUE
Pitch Bend Change 0 (center)
Aftertouch 0 (off)
Polyphonic Aftertouch 0 (off)
Modulation 0 (off)
Expression 127 (max.)
Hold1 0 (off)
Portamento 0 (off)
Sostenuto 0 (off)
Soft Pedal 0 (off)
Portamento Control Cancels the Portamento source key number
RPN Number not specified; internal data will not
change
NRPN